Results 61 to 70 of about 347,352 (352)
Tribological Potential of Hybrid Composites Based on Zinc and Aluminium Alloys Reinforced with SiC and Graphite Particles [PDF]
, 2012 The paper reviews contemporary research in the area of hybrid composites based on zinc and aluminium alloys reinforced with SiC and graphite particles. Metal matrix composites (MMCs) based on ZA matrix are being increasingly applied as light-weight and
B. Stojanović +5 more
core
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
XRD and EDS Investigations of Metal Matrix Composites and Syntactic Foams [PDF]
, 2008 Metal matrix composites (MMCs) of different composition were produced and investigated by X-ray diffraction (XRD) and energy dispersive spectrometry (EDS) analysis.
Dobránszky, János +2 more
core
Modification of as-cast Al-Mg/B4C composite by addition of Zr [PDF]
, 2016 Zirconium was used in Al-Mg/B4C composite to improve compocasting efficiency by increasing particle incorporation. Scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy (EDS) results revealed that by addition of zirconium a reaction
Bahremand, M. R. +4 more
core +2 more sources
Zein‐Based Adhesives: Sustainable Extraction and Application in Bioadhesive Technologies
Advanced Engineering Materials, EarlyView.Zein is extracted from corn gluten meal using a simple and scalable process with high yield (~90%). The resulting protein is applied in bioadhesives modified with Ca2+ and Fe3+ ions, exhibiting substrate‐dependent adhesion. The findings demonstrate competitive bonding performance and highlight the role of ionic interactions in tuning adhesion ...
Paula Bertolino Sanvezzo +3 more
wiley +1 more source
Properties of Metal Matrix Composite of Aluminium 11.8% Silicon Reinforced with Different Particulates [PDF]
, 2006 A composite material is a materials system composed of a mixture or combination of two or more micro or macro constituents that differ in form and chemical composition and which are essentially insoluble in each other.
Vijayaram, Thoguluva Raghavan
core
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
A study on the structural characters of nano hybrid sintered aluminium composites [PDF]
EPJ Web of ConferencesMetal matrix composites play a vital role in automotive and aerospace industries and preparation of such materials with superior strength-to-weight ratio is a challenge for researchers.
R Vinayagamoorthy +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Trace additions of Sn and Sr combined with a two‐step aging treatment are shown to enhance the microstructure and performance of Al–Zr–Sc conductor alloys. Strength and electrical conductivity increase concurrently through accelerated precipitation of fine Al3(Sc, Zr) precipitates and improved dislocation resistance, offering a cost‐effective pathway ...
Quan Shao +3 more
wiley +1 more source
Bean pod ash nanoparticles a promising reinforcement for aluminium matrix biocomposites
Journal of Materials Research and Technology, 2019 Biocomposites is very important in the development of aluminium metal matrix and is attracting research and development worldwide. Composites with bio-reinforcements are ecofriendly, renewable, biodegradable and low cost.
V.S. Aigbodion
doaj +1 more source