Results 81 to 90 of about 196,057 (315)
Assessing Altered Coating Adhesion on Plasma‐Deoxidized Surfaces Under Oxygen‐Free Conditions
Advanced Engineering Materials, EarlyView.This study demonstrates the effectiveness of atmospheric pressure plasma pretreatment in modifying silicon and stainless steel surfaces to improve adhesion. Argon‐hydrogen plasma increases surface roughness and improves adhesion strength, whereas pure argon results in smoother surfaces and structural changes.
Selina Raumel +6 more
wiley +1 more source
Phonon-drag thermopower in cu-al and cu-si alloys [PDF]
Phonon drag thermopower in copper-aluminum and copper-silicon ...
Weinberg, I.
core +1 more source
Advanced Engineering Materials, EarlyView.The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu +8 more
wiley +1 more source
Dynamic response of aluminum alloy plate with initial cracks under repeated impacts
Zhongguo Jianchuan Yanjiu[Objectives] This paper aims to study the effects of initial cracks on the dynamic response of aluminum alloy plate under repeated impacts.[Methods] Through the repeated impact test and finite element simulation of the aluminum alloy plate, we analyze ...
Duan Fangjuan, Liu Jingxi, Xie De
doaj +1 more source
Influence of High-Temperature Treatment of Melt on the Composition and Structure of Aluminum Alloy
Archives of Foundry Engineering, 2017 The aim of the current study was to examine the structure of an alloy treated at various temperatures up to 2,000-2,100 °C. Among research techniques for studying alloy structure there were the electron and optical microstructure, X-ray structure, and ...
Grachev V. A., Turakhodjaev N. D.
doaj +1 more source
Evaluating Energy Absorption Performance of Filled Lattice Structures
Advanced Engineering Materials, EarlyView.Maximum stress must be considered to robustly evaluate energy absorber designs. This approach was applied to compare all types of absorbers in a single Ashby diagram and determine the utility of filling lattice voids with a second material. High‐performance fillers can improve the performance of lattices that are limited by buckling or catastrophic ...
Christian Bonney +2 more
wiley +1 more source
Acid spray technique mills aluminum alloy materials without immersion [PDF]
, 1967 Acid spray machining technique chemically mills aluminum alloy panels without immersing them in an etchant.
Dufour, G.
core +1 more source
Investigation on some factors affecting crack formation in high resistance aluminum alloys [PDF]
, 2017 Aluminum alloys having good mechanical properties are Al-Zn-Mg alloys (7xxx) and Al-Cu-Li alloys (Weldalite®). These alloys may be subjected to stress corrosion cracking.
Brotzu, A., Felli, F., Pilone, D.
core +3 more sources
Advanced Engineering Materials, EarlyView.EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source
Journal of Materials Research and TechnologyAluminum alloy possesses poor plastic deformation ability under quasi-static stamping (QS). Hence, the plastic deformation behavior and microstructure evolution of 5052 aluminum alloy in electromagnetic driven stamping (EMDS) and QS under different heat ...
Rui Li +4 more
doaj +1 more source