Results 31 to 40 of about 55,925 (298)
Journal of Asian Ceramic Societies, 2019 This paper describes a method of applying a silica coating on aluminum nitride and investigations concerning the thermal conductivity between the coating layer and the aluminum nitride as well as the effect of the silica coating layer on the density of ...
Ken’Ichiro Kita, Naoki Kondo
doaj +1 more source
Measurement of nonlinear piezoelectric coefficients using a micromechanical resonator [PDF]
, 2018 We describe and demonstrate a method by which the nonlinear piezoelectric properties of a piezoelectric material may be measured by detecting the force that it applies on a suspended micromechanical resonator at one of its mechanical resonance ...
Boales, Joseph A. +2 more
core +1 more source
Crystals, 2020 Rare-earth-doped SiAlON and Si3N4 materials from aluminosilicate starting materials have been reported to show superior photoluminescence (PL) properties.
Kuizhou Dou +4 more
doaj +1 more source
Thermal conductivity enhancement of aluminum scandium nitride grown by molecular beam epitaxy
Materials Research Letters, 2023 Aluminum scandium nitride (AlScN) has been receiving increasing interest for radio frequency microelectromechanical systems because of their higher achievable bandwidths owing to the larger piezoelectric response of AlScN compared to AlN.
Gustavo A. Alvarez +9 more
doaj +1 more source
Aluminum nitride two-dimensional-resonant-rods [PDF]
Applied Physics Letters, 2020 In the last few decades, bulk-acoustic-wave filters have been essential components of 3G-to-4G radios. These devices rely on the high electromechanical coupling coefficient (kt2 ∼ 7%), attained by aluminum nitride (AlN) film-bulk-acoustic-resonators (FBARs), to achieve a wideband and low-loss frequency response.
Xuanyi Zhao +2 more
openaire +2 more sources
Thermal kinetic inductance detectors for ground-based millimeter-wave cosmology [PDF]
, 2018 We show measurements of thermal kinetic inductance detectors (TKID) intended for millimeter wave cosmology in the 200-300 GHz atmospheric window. The TKID is a type of bolometer which uses the kinetic inductance of a superconducting resonator to measure ...
Bock, James J. +4 more
core +3 more sources
Application of Hybrid Fillers for Improving the Through-Plane Heat Transport in Graphite Nanoplatelet-Based Thermal Interface Layers. [PDF]
, 2015 The in-plane alignment of graphite nanoplatelets (GNPs) in thin thermal interface material (TIM) layers suppresses the though-plane heat transport thus limiting the performance of GNPs in the geometry normally required for thermal management applications.
Haddon, Robert C +2 more
core +2 more sources
Micromachines, 2022 A thin-film strain micro-sensor is a cutting force sensor that can be integrated with tools. Its elastic substrate is an important intermediate to transfer the strain generated by the tools during cutting to the resistance-grid-sensitive layer.
Yongjuan Zhao +3 more
doaj +1 more source
Nanoparticles of wurtzite aluminum nitride from the nut shells
AIP Advances, 2016 Nanoparticles of aluminum nitride were produced from a thermal treatment of a mixture of aluminum oxide (Al2O3) and shells of almond, cashew, coconuts, pistachio, and walnuts in a nitrogen atmosphere at temperatures in excess of 1450 °C. By selecting the
S. B. Qadri +4 more
doaj +1 more source
Механика машин, механизмов и материалов, 2022 A mathematical model is developed for the technological process of synthesis under conditions of high pressures P and temperatures T of a polycrystalline superhard material based on cubic boron nitride (cBN).
Vladimir T. Senyut +2 more
doaj +1 more source