Results 111 to 120 of about 175,741,406 (284)
Advanced Engineering Materials, EarlyView.Copper‐based composites enhanced with carbon feature convenient mechanical properties and favorable electric conductivity. Processing via deformation and thermomechanical treatments can introduce advantageous microstructures further enhancing their performance. Herein, copper–graphene powder‐based composites are directly consolidated via rotary swaging
Radim Kocich +3 more
wiley +1 more source
Indoor Wideband Time/Angle of Arrival Multipath
, 1997 Most current indoor propagation experiments measure the time of arrival of characteristics of multipath reflections without regard to angle of arrival.
Michael Jensen +4 more
core
Hardware Implementation and RF High-Fidelity Modeling and Simulation of Compressive Sensing Based 2D Angle-of-Arrival Measurement System for 2-18 GHz Radar Electronic Support Measures. [PDF]
Sensors (Basel), 2021 Wu C, Krishnasamy D, Elangage J.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.Mass density governs the protective behavior of oxide layers on nuclear fuel cladding. Ptychographic X‐ray computed tomography measures zirconium oxide grown on Zircaloy‐4 under reactor and autoclave conditions, revealing nearly identical bulk densities of 5.1 ± 0.80 g cm−3.
Okan Yetik +9 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Experiments and thermophysical simulations were conducted to investigate the electron beam powder bed fusion electron beam (PBF‐EB/M) process for the γ′‐strengthened nickel‐based superalloy Inconel 738LC. The results demonstrate the impact of process‐induced microstructural variations on high‐temperature mechanical behavior, providing a basis for ...
Jan Niklas Petenati +11 more
wiley +1 more source
Radio-photonic method for angle of arrival determination based on LFM signal
The report presents a radio-photonic method for determining the angle of arrival based on tandem amplitude-phase modulation (TAPM) using a linear frequency-modulated (LFM) signal. Simulation modeling of the scheme was carried out for phase shifts ranging
K.V. Vikulov
core +1 more source
Advanced Engineering Materials, EarlyView.In situ synchrotron high‐energy X‐ray diffraction reveals the real‐time high‐temperature phase evolution of a ternary V‐9Si‐6.5B alloy. The study uncovers a kinetically delayed V5SiB2 → V8SiB4 transformation governed by massive structural and chemical barriers.
Zahra Sabeti +4 more
wiley +1 more source
3D Angle-of-Arrival Positioning Using von Mises-Fisher Distribution
, 2018 We propose modeling an angle-of-arrival (AOA) positioning measurement as a 3-dimensional von Mises-Fisher (VMF)-distributed unit vector instead of the conventional normally distributed azimuth and elevation measurements.
Nurminen, Henri +7 more
core +1 more source
Impact of MgO Additions on the Oxidation Resistance and Compression Behavior of Vanadium Alloys
Advanced Engineering Materials, EarlyView.An increase in oxidation resistance at 600 °C is achieved for alloys containing more than 2.5 wt.% MgO. It has been established that, along with V2O5, MgO6V2, and Mg2O7V2 are formed, which are presumed to enhance oxidative stability. Furthermore, the possible transformation of Mg‐vanadates through reaction with CO2, which presumably occurs in this ...
Ievgen Solodkyi +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Schematic representation of modes of microcrack nucleation, growth and temporary arrestment at different boundaries, with the criteria for crack propagation in three scenarios: (1) large notch, (2) defect/small sharp notch, and (3) long crack. This work revisits and integrates results on the fatigue behavior of advanced bainitic steels (in particular ...
Lucia Morales‐Rivas
wiley +1 more source