Results 141 to 150 of about 165,996,826 (275)
Advanced Engineering Materials, EarlyView.Different Al/Al bimetals with a single engineered interface reveal how mechanical mismatch governs fatigue crack growth under cyclic loading. Additionally, loading–unloading–reloading tests link the microyielding behavior to the fatigue crack growth resistance, while crack‐path analysis reveals toughening mechanisms at the interface, highlighting ...
Sebastian Vollath +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Schematic representation of modes of microcrack nucleation, growth and temporary arrestment at different boundaries, with the criteria for crack propagation in three scenarios: (1) large notch, (2) defect/small sharp notch, and (3) long crack. This work revisits and integrates results on the fatigue behavior of advanced bainitic steels (in particular ...
Lucia Morales‐Rivas
wiley +1 more source
Robust Time-Delay Based Angle of Arrival Estimation
, 2008 The differences in the arrival times of a signal at spatially separated sensors can be used to estimate the angle of arrival of the signal. Due to noise or sensor malfunction, the time difference estimates may be erroneous and thus the angle of arrival ...
core
Advanced Engineering Materials, EarlyView.Controlling the Field Assisted Sintering Technology (FAST) parameters, dwell temperature and cooling rate, significantly influences the microstructural evolution in titanium aluminide GE4822. Significant γ‐lamellar colonies develop only upon cooling through the α‐transus.
Jack Krohn, James Pepper, Martin Jackson
wiley +1 more source
ABSTRACT TIME-DELAY SELECTION FOR ROBUST ANGLE OF ARRIVAL ESTIMATION
, 2008 The differences in the arrival times of a signal at spatially separated sensors can be used to estimate the angle of arrival of the signal. Due to noise or sensor malfunction, the time difference estimates may be erroneous and thus the angle of arrival ...
core
Angle of arrival of ten centimeter microwaves
, 1955 The path of an electromagentic wave propagated through the earth's atmosphere depends upon the homogeneity of the atmosphere. For the well mixed condition, which is the case most of the time, the wave follows a straight or a smoothly curved path. However,
Nelms, George Leroy Batten
core +1 more source
Advanced Engineering Materials, EarlyView.Deep‐UV (258 nm) femtosecond pulses enable uniform amorphous silicon writing on Si(100)/(111) with a six‐fold larger fluence amorphization window than NIR methods. Optimized fluence and overlap yield 20–45 nm uniform and continuous amorphous layers. Microscopy shows sharp interfaces, and real‐time reflectivity reveals nanosecond melt–resolidification ...
Wissal Benali +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Solvate ionic liquids lubrication reduced the coefficient of friction by ∼60% compared to dry sliding, reaching steady‐state values as low as 0.04–0.05. Corrosion weight‐loss measurements in 1 M HCl further demonstrated significant inhibition behavior, with only 100 ppm of [Li(G3)][TFSI] (∼68.5 μL/L) reducing corrosion‐product weight loss by 63 ...
Sameh Dabees +6 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Geometrical modifications on nitrocellulose membranes can result in observable differences in signal intensity relative to a reference membrane (top and bottom left). Using two reference experiments, we have developed a theoretical model that can reproduce the experimentally observed flow changes and provide information on membrane parameters, e.g ...
Maria Dimaki +2 more
wiley +1 more source
Rydberg-Atom-Based Angle-of-Arrival Estimation Method for Ku-Band Microwave Signals. [PDF]
Sensors (Basel)Hu X +5 more
europepmc +1 more source