Results 51 to 60 of about 565,913 (252)
Diffusion Behavior and Kinetics of the Iron–Nickel Interface During Annealing Treatment
The notorious corrosion resistance of carbon steel significantly limits its scope of application. In this study, a strategy involving electrodeposited nickel followed by annealing was proposed to improve the corrosion resistance of materials. The effects
Wenlin Wu +4 more
doaj +1 more source
Microstructure and Mechanical Properties of as Cast Al-6.5Mg-1.5Zn-0.5Fe Alloy Followed by Cold Rolling and Subsequent Annealing [PDF]
Microstructures and mechanical properties of as-cast Al-6.5Mg-1.5Zn-0.5Fe alloys newly alloy-designed for the parts of automobile were investigated in detail.
Seong-Hee Lee
doaj +1 more source
Human ABCE1 cannot functionally replace its yeast ortholog. Yeast–human chimera analysis identified NBD1 as a major interspecies barrier. Genetic screening yielded hABCE1 revertants that rescue yeast viability but fail to suppress aberrant translation reinitiation in the 3′ UTR.
Eriko Nakata +3 more
wiley +1 more source
Influence of Recrystallization Annealing on the Properties and Structure of Low-Carbon Ferritic Steel IF [PDF]
This paper shows results of researches of a structure and mechanical properties of metal sheets of IF steels subjected torecrystallization annealing. The annealing was held in the scope of the temperature of 600-900°C over 25 min time. The impact of heat
K. Kowalczyk +3 more
doaj +1 more source
Bi‐ and Mono‐Allelic RFC1 Expansion in a North American Cohort With Idiopathic Axonal Neuropathy
ABSTRACT Objective RFC1 biallelic repeat expansion is increasingly recognized as a cause of chronic idiopathic axonal polyneuropathy (CIAP), but it remains challenging to know who to test. This study aims to determine the prevalence of biallelic and monoallelic RFC1 expansions and their corresponding neuropathy phenotypes in CIAP patients and identify ...
Amro M. Stino +25 more
wiley +1 more source
Penumbuhan lapisan tipis BaZr0,15Ti0,85O3 telah dilakukan menggunakan metode sol gel di atas substrat Pt/Si yang disiapkan dengan spin coater. Penumbuhan lapisan tipis menggunakan variasi suhu annealing 8000C dan 9000C, dan variasi waktu tahan (holding ...
S Hadiati +6 more
doaj
Variation in Mechanical Properties of Ti-13Nb-13Zr Depending on Annealing Temperature
Ti-13Nb-13Zr alloy is an orthopedic implant material possessing good mechanical properties, corrosion resistance, and biocompatibility. An international standard suggests a heat treatment known as “capability aging” for this alloy.
Taekyung Lee
doaj +1 more source
Objective Systemic lupus erythematosus (SLE) significantly impacts employment capacity. This study aimed to investigate the impact of burden of disease activity, damage, and treatment on employment outcomes and transitions in patients with SLE. Methods Using data from a single center, we analyzed employment transitions, adjusted mean disease activity ...
Javier Mencia‐Ledo +4 more
wiley +1 more source
Impedance Spectroscopy for Interface Trap Effects Evaluation in Dopant-Free Silicon Solar Cells
This work investigates the effect of interface traps on the impedance spectra of dopant-free silicon solar cells. The studied device consists of a crystalline silicon absorber with an a-Si:H/MoOx/ITO stack as the front passivating hole-collecting contact
Ilaria Matacena +9 more
doaj +1 more source
ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur +5 more
wiley +1 more source

