Results 111 to 120 of about 38,550 (309)

Matlab® Algorithm to Simulate the Dynamic Behavior of an NiTi Alloy through Ansys® APDLTM Models

, 2020
Jean César Hilário, Manuel Braz-César, C.A.R. Andrade, Adailton Silva Borges   +3 more
openalex   +2 more sources

A study of chevron type plate design on pressure drop and friction factor of brazed plate heat exchanger

Environmental Progress &Sustainable Energy, EarlyView.
Abstract Brazed plate heat exchanger (BPHE) was analyzed using computational fluid dynamics (CFD) simulations by ANSYS Fluent to investigate the chevron‐patterned plates. The influence of geometric parameters, including corrugation pitch, depth, and angle was analyzed.
J. S. Huang, K. B. Then, X. W. Wang
wiley   +1 more source

Simulation Analysis of the Performance of an Environmentally Friendly Double-suction Cutter Suction Dredger Based on SolidWorks and ANSYS

, 2018
Ting Xiong, Junyu Li, Hongjie Jia, Bowen Hou, Weigang Zheng   +4 more
openalex   +1 more source

Linear and Non-Linear Stress Analysis for the Prediction of Fracture Toughness for Brittle and Ductile Material using ASTM E399 and ASTM E1290 By ANSYS Program package [PDF]

, 2019
Ameen Nassar, E G Fayyad
openalex   +1 more source

Low‐Cost Friction‐Based Force‐Limiting Connection With Reduced Sensitivity to Machining Tolerances and Accelerated Repairability

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT This paper presents a novel yet practical friction‐based structural component design for low‐damage earthquake‐resistant structures. The proposed connection design is based on a conventional slotted‐bolted configuration with the novelty being the use of loose steel washer plates to establish the friction‐sliding interface.
Kaixin Chen, Georgios Tsampras, Chung‐Che Chou, Huang‐Zuo Lin, Chi‐Jeng Wu, Alvaro Córdova, Chia‐Ming Uang, Shih‐Ho Chao   +7 more
wiley   +1 more source

Modeling Functionally Graded Materials in ANSYS APDL

, 2022
Ahmed Hassan Ahmed Hassan, Naci Kurgan
openalex   +1 more source

Force-displacement relationships for NiTi alloy helical springs by using ANSYS: Superelasticity and shape memory effect [PDF]

, 2022
Chayma El Mtili, Abdellatif Khamlichi, Loubna Hessissen, Hafiz Muhammad Waqas Badar   +3 more
openalex   +1 more source

Research on Thermal Runaway Multiphysics Coupling Simulation and Sensor Optimization Layout of Lithium Iron Phosphate Energy Storage Battery Packs

Energy Science &Engineering, EarlyView.
This study explores thermal runaway in lithium‐iron‐phosphate energy storage battery packs through multi‐physics coupling simulation. Thermal runaway evolves from battery cells (experiencing overcharge, bulging, safety valve opening, and gas venting) to battery clusters (a) and propagates within the battery pack (b). Simulation results indicate: stress
Dongliang Guo, Lei Sun, Rong Sun, Jun Jia, Peng Xiao, Hailong Ruan, Xin Jiang   +6 more
wiley   +1 more source

Multiphysical Modeling and Simulation of Battery Cells and Systems Using Ansys Mechanical

, 2023
Robert Kießling
openalex   +1 more source

Effects of Concentrations of Water‐Based MgO Nanofluid on Heat Transfer Performance in Shell‐and‐Tube Heat Exchanger

Energy Science &Engineering, EarlyView.
This figure shows the variation of the total heat transfer coefficient of a shell and tube heat exchanger with different concentrations of water‐based MgO nanofluids at different inlet flow rates. The results indicate that the total heat transfer coefficient increases with increasing flow velocity, and at different volume fraction settings, the ...
Li Zhang, Yifan Cheng, Yang Liu, Yongju Zhang, Ziyun Chen   +4 more
wiley   +1 more source