Results 161 to 170 of about 171,290 (313)
This figure shows the variation of the total heat transfer coefficient of a shell and tube heat exchanger with different concentrations of water‐based MgO nanofluids at different inlet flow rates. The results indicate that the total heat transfer coefficient increases with increasing flow velocity, and at different volume fraction settings, the ...
Li Zhang +4 more
wiley +1 more source
Integration of Pomacea canaliculata shell waste for low-carbon sustainable creative material design. [PDF]
Aduldejcharas R.
europepmc +1 more source
This study investigates the heat transfer characteristics of copper‐foam composite phase change materials with different gradient porosities. Three models with uniform porosity and three models with gradient porosities are developed to examine their effects on temperature distribution and melting behavior. ABSTRACT Phase change materials (PCMs) exhibit
Wei Yang +6 more
wiley +1 more source
Nonlinear analysis of hollow reinforced high strength concrete beams with web openings and different types of stirrups under torsion. [PDF]
Ebrahim FA, Askar HS, El-Zoughiby ME.
europepmc +1 more source
Downdraft Devices for Negative Emissions—Quantification Study and Environmental Implication
ABSTRACT Methane (CH4) is a potent greenhouse gas with a global warming potential far exceeding that of CO2 over short time horizons. Its removal from the atmosphere remains challenging due to its low ambient concentration and chemical stability. This study explores downdraft energy towers (DETs) as an innovative CH4 mitigation technology that enhances
Xiaokun Yao +4 more
wiley +1 more source
Quantitative analysis of the influence of faults on deep in situ stress under different stress types. [PDF]
Zheng P +11 more
europepmc +1 more source
ABSTRACT Traditional numerical methods, such as finite difference methods (FDM), finite element methods (FEM), and spectral methods, often face meshing challenges and high computational cost for solving nonlinear coupled differential equations. Machine learning techniques, specifically Physics‐informed machine learning, address these obstacles by ...
Ahmad, Feroz Soomro, Husna Zafar
wiley +1 more source
CFD Analysis of Dual‐Layer PCM Roofs for Thermal Mitigation in Residential Buildings
ABSTRACT This study presents a computational fluid dynamics analysis of dual‐layer phase change material (PCM) roofs for passive cooling in residential buildings under the hot and humid climate of Bangladesh. A three‐dimensional transient model was developed in ANSYS Fluent using the enthalpy–porosity approach to simulate coupled heat conduction ...
Mohammad Junaid +6 more
wiley +1 more source
In randomly distributed Cu2O octahedron particles on a glass substrate, the absence of particles in certain areas generates a distinct “void‐particle induced interference” phenomenon. This effect results in notable reflection and transmission dichroism, characterized by two reflection peaks within the visible spectrum, but only a single transmission ...
Yaqun Han +5 more
wiley +1 more source
Digital simulation of rock grinding process in ball mill. [PDF]
Chanturia VA +7 more
europepmc +1 more source

