Results 261 to 270 of about 925,742 (303)
Some of the next articles are maybe not open access.
2012 9th International Conference on Fuzzy Systems and Knowledge Discovery, 2012
Through collecting the real time control error in the area of power grid and power generation error of the generating units in Hunan Province, combined with ultra-short term load forecasting, established the new feedback control system considering the load error, area control error and generating unit error, we can guide real-time scheduling of the ...
Dun-Nan Liu +3 more
openaire +1 more source
Through collecting the real time control error in the area of power grid and power generation error of the generating units in Hunan Province, combined with ultra-short term load forecasting, established the new feedback control system considering the load error, area control error and generating unit error, we can guide real-time scheduling of the ...
Dun-Nan Liu +3 more
openaire +1 more source
Autoregressive moving average modeling of area control error
2017 IEEE Power & Energy Society General Meeting, 2017Area control error (ACE) is a quantity used by balancing authorities to perform frequency regulation in bulk power systems. Recently, increased variations in ACE were seen in second-to-second timescale as a result of rising volatile power generation such as wind.
Shuthakini Pulendran, Joseph Euzebe Tate
openaire +1 more source
Error control strategy in ultrasonic Body Area Networks
China Communications, 2016Recently, ultrasonic waves had been introduced as the transmission medium in Body Area Networks (BANs) to reduce the incalculable damage caused by radio waves. However, the communications based on ultrasonic waves suffer from poor propagation of signals in air and consume too much energy.
null Wenbin Liu +3 more
openaire +1 more source
Message delay time distribution analysis for controller area network under errors
Frontiers of Information Technology & Electronic Engineering, 2019Controller area network (CAN) is a widely used fieldbus protocol in various industrial applications. To understand the network behavior under errors for the optimal design of networked control systems, the message response time of the CAN network needs to be analyzed.
Leiming Zhang, Yi-chao Sun, Yong Lei
openaire +1 more source
Quality of service support in wireless local area network with error control protocol
2008 33rd IEEE Conference on Local Computer Networks (LCN), 2008In this paper, we applied an error control protocol for wireless local area network in medium access control. Hiperlan\2 random access phase is taken as an example. We applied quality of service support in the random access phase. Analytical model is developed for the backoff strategy with error control protocol. The performance metrics are shown.
Abdelsalam B. Amer +2 more
openaire +1 more source
Energy Efficient Raptor Codes for Error Control in Wireless Body Area Networks
Wireless Personal Communications, 2018WBAN consists of several tiny sensors that are located inside and outside human body for continuous monitoring of vital parameters of patients suffering from chronic diseases. The wearable sensor unit consists of transmitter, receiver and central process unit (gateway). The gateway is used to connect wearable sensors on human body to the internet.
P. Kaythry, R. Kishore, V. Praveena
openaire +1 more source
A fault-tolerant ICAP controller with a selective-area soft error mitigation engine
2017 NASA/ESA Conference on Adaptive Hardware and Systems (AHS), 2017Dynamic partial reconfiguration (DPR) allows runtime access to the configuration memory (CMEM) of FPGAs. A key function that relies on DPR is task reconfiguration, where circuits are multiplexed in time and space in order to reduce device count and cost. Moreover, in mission-critical applications, DPR is used for soft error mitigation (SEM).
Adewale Adetomi +2 more
openaire +1 more source
IEEE Transactions on Power Systems, 1995
Power system control areas within three major (and essentially separate) areas of North America are interconnected electrically, thus enjoying vastly improved reliability and economy of operation compared to operating in isolation. Each must continually balance load, interchange and generation to minimize adverse influence on neighboring control areas ...
openaire +1 more source
Power system control areas within three major (and essentially separate) areas of North America are interconnected electrically, thus enjoying vastly improved reliability and economy of operation compared to operating in isolation. Each must continually balance load, interchange and generation to minimize adverse influence on neighboring control areas ...
openaire +1 more source
Using EASY5 to investigate filtering of power system area control error
Proceedings of 26th Southeastern Symposium on System Theory, 2002The area control error (ACE) is an indication of the mismatch between generation and load demand of a power system. This signal is an integral part of the automatic generation control (AGC) system which seeks to match area generation and load on a moment to moment basis.
W.C. Grantham, R.L. King
openaire +1 more source
An integral square error-based model predictive controller for two area load frequency control
Advances in Energy Research, 2017The main objective of load frequency control (LFC) is to keep the frequency value at nominal value and force deviation of the frequency to zero in case of load change. This paper suggests LFC by using a model predictive control (MPC), based on Integral Square Error (ISE) method designed to optimize the damping of oscillations in a two-area power system.
Ahmed M. Kassem +3 more
openaire +1 more source