Results 71 to 80 of about 311,592 (233)
DIVIMP-B2-EIRENE modelling of 13C migration and deposition in ASDEX-Upgrade L-mode plasmas
Carbon transport and migration were studied experimentally and numerically in a high-density, low-confinement mode plasma in the ASDEX Upgrade tokamak.
Asunta, O. +10 more
core +2 more sources
Divertor power deposition and target current asymmetries during type-I ELMS in ASDEX Upgrade and JET [PDF]
Analysis of the type-l ELM power load asymmetries using infra-red thermography and target current measurements is performed ASDEX Upgrade Upper Single Null and JET DOC-L type-I ELMy H-Mode discharges with 'normal' and,reversed' field direction, i.e. with
JET-EFDA Contributors +10 more
core +1 more source
Inter-discharge optimization for fast, reliable access to ASDEX Upgrade advanced tokamak scenario
Rapid inter-discharge simulation and optimization using the RAPTOR code have allowed the development of a reliable and reproducible early heating strategy for an advanced tokamak (AT) scenario on ASDEX Upgrade.
S. van Mulders +10 more
semanticscholar +1 more source
The orbit-following Monte Carlo code ASCOT interfaced with the radiofrequency Monte Carlo library RFOF can simulate radiofrequency heating of ion populations using wave solutions from full-wave solvers such as TORIC. It is applied to the fundamental mode
S. Sipilä +11 more
semanticscholar +1 more source
The effect of non-axisymmetric wall geometry on 13C transport in ASDEX Upgrade
We present the first results of 3D simulations of global 13C transport in ASDEX Upgrade (AUG) indicating that the deposition profile of 13C exhibits toroidal asymmetry in the main chamber.
Hakola, Antti; id_orcid +11 more
core +2 more sources
Low frequency sawtooth precursor activity in ASDEX Upgrade [PDF]
This paper describes the precursor activity observed in the ASDEX Upgrade tokamak before sawtooth crashes in various neutral beam heated plasmas, utilizing the soft x-ray diagnostic. In addition to the well-known (m, n) = (1,1) internal kink mode and its
M Maraschek +32 more
core +1 more source
New boronization system at ASDEX Upgrade
The coating of plasma facing components (PFC) with boron significantly improves the performance of plasma operation in magnetic fusion devices. The boron layer traps residual oxygen in the vacuum vessel, thus reducing radiative losses due to collisions ...
M. Dibon +4 more
semanticscholar +1 more source
Migration of 13C and deposition at ASDEX Upgrade
To investigate material transport in scrape-off layer plasma and long term deposition in divertor, 13CH4 was puffed at the end of 2004 and 2005 experimental campaigns into ASDEX Upgrade from the outer mid-plane.
Vainonen-Ahlgren, E. +8 more
core +1 more source
Heat transport at the boundary of ASDEX Upgrade [PDF]
The flow of heat in the scrape-off layer (SOL) region of ASDEX Upgrade is investigated and compared with simple modelling. Parallel heat transport is found to be consistent with electron heat conduction based on Spitzer - H?rm conductivity. Cross-field heat transport is characterized using radial e-folding distances for power, temperature and plasma ...
Pitcher, C. +8 more
openaire +2 more sources
Carbon erosion and deposition on the ASDEX Upgrade divertor tiles
Carbon deposition and erosion were measured on ASDEX Upgrade divertor tiles and below the roof baffle during the operation period 2002/2003. The inner divertor is a net carbon deposition area, while a large fraction of the outer divertor is erosion ...
Vainonen-Ahlgren, E. +9 more
core +2 more sources

