Results 1 to 10 of about 1,482,813 (348)
Fault Current Characteristics of the DFIG under Asymmetrical Fault Conditions [PDF]
Energies, 2015 During non-severe fault conditions, crowbar protection is not activated and the rotor windings of a doubly-fed induction generator (DFIG) are excited by the AC/DC/AC converter.
Fan Xiao, Zhe Zhang, Xianggen Yin
doaj +3 more sources
Improved DFIG capability during asymmetrical grid faults [PDF]
IECON 2015 - 41st Annual Conference of the IEEE Industrial Electronics Society, 2015 In the wind power application, different asymmetrical types of the grid fault can be categorized after the Y/d transformer, and the positive and negative components of a single-phase fault, phase-to-phase fault, and two-phase fault can be summarized.
Dao Zhou, Frede Blaabjerg
core +7 more sources
CSEE Journal of Power and Energy Systems, 2021 Since the fault dynamic of droop-controlled inverter is different from synchronous generators (SGs), protection devices may become invalid, and the fault overcurrent may damage power electronic devices and threaten the safety of the microgrid. Therefore,
Huimin Zhao +5 more
doaj +2 more sources
Energies, 2016 Numerous industrial applications involve loads that are very sensitive to electrical supply instabilities. These instances involve various types of voltage imbalances as well as more serious disturbances such as symmetrical and asymmetrical faults.
Syed Sabir Hussain Bukhari +3 more
doaj +2 more sources
An Adaptive Fault Ride-Through Scheme for Grid-Forming Inverters Under Asymmetrical Grid Faults
IEEE Transactions on Industrial Electronics, 2022 202206 bchy ; Accepted Manuscript ; RGC ; Others ; Innovation and Technology Commission of the HKSAR Goverment ; Published ; Green (AAM)
Zilin Li +3 more
openaire +3 more sources
A Novel Technique for Asymmetrical Fault A Novel Technique for Asymmetrical Fault Detection
Bulletin of Electrical Engineering and Informatics, 2012 Qingchao Yang +3 more
semanticscholar +4 more sources
Fault Tolerant CCS-MPC for Asymmetrical DTP-PMSM Drives Assisted by Fault Detection Algorithm
IEEE AccessFault tolerance is a highly desirable feature for safety-critical electric drive applications. This paper proposes an open-circuit fault tolerant model predictive controller (FT-MPC) for asymmetrical dual three-phase (DTP) permanent magnet synchronous ...
Adriano Navarro-Temoche +4 more
doaj +3 more sources
Active fault tolerant control for twin wind turbine subject to asymmetric fault [PDF]
2021 International Conference on Control, Automation and Diagnosis (ICCAD), 2021 This paper addresses the problem of control of a twin wind turbine which is subject to an electrical fault affecting only one stator phase of one turbine. An active fault tolerant control is proposed. The performance and robustness of the proposed control, comparing to a passive fault tolerant one developed in the literature, are shown through ...
Makni, Mariem +5 more
openaire +3 more sources
IEEE transactions on industry applications, 2023 As the number of converter-interfaced distributed energy resources connected to the power system continues to increase rapidly, recent grid codes require these grid-tied converters to maintain grid connection during faults to ensure power supply security
Md Rifat Kaisar Rachi +2 more
semanticscholar +1 more source
Simulation-based post-fault analysis in WECS using DFIG systems under an unbalanced fault scenario
Journal of Applied Research in Technology & Engineering, 2023 Fault analysis in an integrated Wind Energy Conversion System (WECS) is the highest priority factor to be taken into account for distributed generation (DG).
Muzamil Hussain Wadho +3 more
doaj +1 more source