Grinding Metamorphic Layer of Bearing Steel: Formation Mechanisms, Characterization, and Process Parameter Effects. [PDF]
Materials (Basel)Guo J +6 more
europepmc +1 more source
Experimental and numerical investigation of the post‐fire fracture behaviour of H500 stainless steel
ce/papers, Volume 9, Issue 2-3, Page 329-334, September 2026.Abstract This paper presents an experimental and numerical investigation into the fracture behaviour of H500 austenitic stainless steel following exposure to elevated temperatures. The post‐fire integrity of stainless steel is a critical consideration in structural fire engineering, yet data for newly developed grades remain limited.
Zhichang Pan +3 more
wiley +1 more source
Effect of Austempering on the Microstructure, Mechanical Properties and Tribological Performance of EN-GJS-800-8 Ductile Iron Castings. [PDF]
Materials (Basel)Jaroszek J +3 more
europepmc +1 more source
Bending Behaviour of Stainless Steel I‐beams with Sinusoidal Corrugated Webs
ce/papers, Volume 9, Issue 2-3, Page 311-316, September 2026.Abstract This paper presents an experimental and numerical study on stainless steel I‐beams with sinusoidal corrugated webs. To explore the bending behaviour of stainless steel sinusoidal corrugated web girders two full‐scale specimens were tested under four‐point bending conditions.
Gábor Hajdú
wiley +1 more source
Martensitic Transformation and Strengthening Mechanism in a 304 Stainless Steel Subjected to Wire Drawing. [PDF]
Materials (Basel)Yu Y, Fu W, Dai F, Li R, Lai Q.
europepmc +1 more source
Out‐of‐plane stability design of stainless steel beams by GMNIA with strain limits
ce/papers, Volume 9, Issue 2-3, Page 2050-2054, September 2026.Abstract Design by geometrically and materially nonlinear analysis with imperfections (GMNIA) using beam finite elements and strain limits has emerged as an accurate and efficient design approach, capturing the key structural behaviour while reducing the need for separate cross‐section classification and member design checks.
Hongrui Lin, Chunyan Quan, Fiona Walport
wiley +1 more source
Effects of V, Nb, Si, Mn, Mo on Microstructural Evolution and Strength-Toughness Balance of P20 Plastic Mold Steel. [PDF]
Materials (Basel)Zhao L +6 more
europepmc +1 more source
ce/papers, Volume 9, Issue 2-3, Page 424-429, September 2026.Abstract Additively manufactured materials are increasingly utilized for producing customized components across various industries, including civil engineering and aerospace. These surfaces often necessitate a smooth finish, which can be attained through post‐processing techniques alongside carefully controlled process parameters.
Mohsen Falah +5 more
wiley +1 more source
Effects of Heat Treatment Procedures and Diamond Burnishing on Tensile Properties and Surface Integrity of Additively Manufactured 17-4PH Steel Cylindrical Parts. [PDF]
Materials (Basel)Duncheva G +7 more
europepmc +1 more source
Engineering Reports, Volume 8, Issue 9, September 2026.Systematic framework has been established to model, analyze, and optimize the properties of SLM parts. The major results drawn from the proposed work: CCD‐based modeling for density and UTS of SLM‐fabricated SDSS 2507. Scan speed showed the highest influence on density and tensile strength.
Tejas Ramesh +6 more
wiley +1 more source