Results 211 to 220 of about 48,227 (268)

Mechanical and Energy Absorption Properties of Porous Royal Water Lily Leaf Vein Cross-Sections Under Quasi-Static Axial Loading. [PDF]

Biomimetics (Basel)
Guo Z, Luo S, He X, He Y, Bai C, Wang Z.
europepmc   +1 more source

Knitted Pneumatic Fabrics for Dynamic Pressure Modulation in Personalized Healthcare Wearables. [PDF]

Adv Sci (Weinh)
Chen X, Fan J, Zheng R, Chen Q, Sun F, Liu H.   +5 more
europepmc   +1 more source

Study on the anisotropic characteristics of mechanical properties and energy evolution in layered phyllite. [PDF]

PLoS One
Chen L, Xi B, Zhao N, Dong Y, He S, Liu K, Gao P, Xie J.   +7 more
europepmc   +1 more source

Axial compression testing of vacuum tube glass-ceramic/molybdenum frames

, 1980
openaire   +2 more sources

Some of the next articles are maybe not open access.

Related searches:

Axial Compression Tests of Cold-Formed Angles

Journal of Structural Engineering, 1999
This paper presents fixed-ended and pin-ended compression tests on cold-formed, in-line galvanized equal angles. Three nominal section sizes were tested ranging from nonslender to slender sections. Detailed measurements of material properties, residual stresses, and geometrical imperfections were conducted.
D. Popovic, G. J. Hancock, K. J. R. Rasmussen   +2 more
openaire   +1 more source

Axial Compression Test of RC Columns Consolidation with BFRP

Applied Mechanics and Materials, 2012
12 RC columns were made, including nine RC columns wrapped with BFRP, three RC columns without any reinforcement, to conduct the comparative study of axial compression. The result shows that the bearing capacity of the RC columns reinforced with the fibers increases obviously.The displacement ductility factor increases, but its increase rate becomes ...
Bao Rong Huo, Xiang Dong Zhang
openaire   +1 more source

Axial Compression Tests on ITER-TF Conductor Samples

IEEE Transactions on Applied Superconductivity, 2010
As demonstrated in the -superconductor cable of the ITER TF Model Coil (TFMC) has an average longitudinal stiffness inside the stainless steel jacket of about 1/10 of that calculated supposing all components are fully bonded. This conductor was wound towards the inner circumference of the grooves of a stainless steel mould and heat treated in it showed
H Fillunger, R K Maix, R Prokopec, P Dobron, A Danninger   +4 more
openaire   +1 more source