Results 31 to 40 of about 37,200 (306)
Compressive Behavior of a Fully Prefabricated Liftable Connection for Modular Steel Construction
Buildings, 2022 Modular steel construction (MSC) consists of the off-site prefabrication of a fully finished module and the on-site assembling of the module unit. The popularity of MSC is on the rise, attributable to its technical advantages of speed and quality of ...
En-Feng Deng +5 more
doaj +1 more source
Vestnik MGSU, 2022 Introduction. This study presents the results of an experimental assessment of the simultaneous impact of corrosion and the reinforcement ratio on the load-bearing capacity of standard reinforced concrete elements subjected to axial compression. Materials and methods.
Emmanuel Mikerego, Niyokindi Lionel
openaire +1 more source
The bearing capacity performance of upvc pipe under axial compression
Case Studies in Construction MaterialsThe un-plasticized polyvinyl chloride (UPVC) is increasingly used in the construction industry because of its superior properties, particularly in greenhouses with UPVC as the skeleton. This study investigated the bearing capacities of UPVC pipes under axial compression.
Shuquan Xu +5 more
openaire +2 more sources
Applied Sciences, 2023 This study aimed to investigate the axial compression performance of concrete-filled circular-end aluminum tube (RECFAT) columns, utilizing four specimens with varying parameters such as cross-sectional aspect ratio and cross-sectional aluminum content.
Jianqing Bu +3 more
openaire +2 more sources
Strength correlation between individual block, prism and basic wall panel for load bearing interlocking mortarless hollow block masonry [PDF]
, 2006 This paper focuses on the development of the compressive strength correlation between the individual block, prism and basic wall panel for load bearing interlocking hollow mortarless blocks.
Abang Ali, Abang Abdullah +4 more
core +1 more source
The Scientific World Journal, 2014 The axial compressive strength of unidirectional FRP made by pultrusion is generally quite lower than its axial tensile strength. This fact decreases the advantages of FRP as main load bearing member in engineering structure.
Feng Li +3 more
doaj +1 more source
Applied Sciences, 2021 This study aims to investigate the ultimate bearing capacity of a novel tubular K-joint used for light-steel structures consisting of thin-walled square hollow section members, a U-shape connector and self-drilling screws, and the effect of three ...
Xiaoping Wang +6 more
doaj +1 more source
Damage assessment of concrete structures exposed to fire [PDF]
, 2013 During a fire, concrete structures behave in most cases very well. It could therefore be of economic interest to repair the damaged structures, as costs for demolition and rebuilding can be avoided and the building can be reused faster.
Annerel, Emmanuel, Taerwe, Luc
core +1 more source
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
VHF adaptive antenna using a rear defogger [PDF]
, 2012 This thesis presented the design of an adaptive bearnforming antenna using a rear defogger. The main purpose of this project is to develop the vehicular adaptive antenna for VHF band, which does not require the installation space, does not spoil the
Abdullah, Noorsaliza
core