Results 81 to 90 of about 2,035 (263)
Авіаційно-космічна техніка та технологія, 2019 Gas Turbine Engine (GTE) operating characteristics such as thrust (or power), specific fuel consumption and other cycle parameters on different regimes, can be determined by engine modeling and applying correspondent calculation method.
Людмила Георгиевна Бойко +2 more
doaj +1 more source
A Dislocation Perspective on Strength and Toughness in Ceramics
Advanced Engineering Materials, EarlyView.Dislocations in ceramics enjoy a long but yet under‐appreciated history. The three research waves for dislocations in ceramics highlight the topic evolution over the last 90 years. This review focuses on the impact of dislocation on strength and toughness in ceramics.
Xufei Fang
wiley +1 more source
Axial compressor blade cascade
, 2020 Axial compressor blade cascade ...
Yershov, V.N. +4 more
openaire +1 more source
Experimental Characterization of Mycelium‐Based Composites Under Multiple Loading Conditions
Advanced Engineering Materials, EarlyView.This study examines the mechanical response of mycelium‐based composites under compression, shear, and tension using mechanical testing and imaging methods. The comparison between unpressed and hot‐pressed specimens shows that hot pressing is associated with higher compression and shear stiffnesses.
Shaghayegh Elahi +5 more
wiley +1 more source
End-wall slotting effects on axial velocity density ratio of supersonic compressor cascade
Kongqi donglixue xuebaoIn addressing the issue of adjusting the axial velocity density ratio in experiments with supersonic compressor planar cascades, numerical simulations were employed to investigate the impact of end-wall slotting on the flow field of the supersonic ...
Wei Wei +4 more
doaj +1 more source
Comparison of Triply Periodic Minimal Surface Energy Absorbers Under Uniaxial Compressive Loading
Advanced Engineering Materials, EarlyView.This study investigates LCD 3D printed Triply Periodic Minimal Surface (TPMS) structures as mechanical energy absorbers. By comparing various base designs and layered combinations under uniaxial compression, it identifies that a Diamond‐Gyroid sandwich structure offers superior performance.
Sergej Grednev +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Molecular dynamics is used to investigate structure refinement during severe plastic deformation. The results show similitude with experimental data. Molecular dynamics simulations of severe plastic deformation of monocrystalline and polycrystalline samples by multiaxial compression of aluminum are carried out.
Roberto B. Figueiredo
wiley +1 more source
, 2015 This dissertation describes the experimental investigation of rotating stall in compressors of high hub-tip ratio. Measurements were obtained in builds of one to four stages, covering a wide range of design flow rates and also a change in design reaction. The purpose of the experimental work has been to gain a better understanding of the details of the
openaire +1 more source
Research on the adjustment mechanism of inlet guide vanes in axial compressors
Xibei Gongye Daxue XuebaoTo further elucidate the adjustment mechanism of inlet guide vanes in axial compressors of aero-engines, this paper investigates a 1.5-stage high-load compressor using numerical simulation methods. This study comprehensively examines the influence law of
YAO Yao +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.X‐ray computed tomography reveals how process‐induced defects evolve from green to sintered states in Fused Filament Fabrication (FFF)‐manufactured 17‐4PH stainless steel. Internal porosity, weakest cross‐sections, and fracture locations show strong correlation with tensile performance, demonstrating the potential of computed tomography (CT)‐based ...
György Ledniczky +3 more
wiley +1 more source