Results 11 to 20 of about 10,149,535 (194)
Ultimate axial load capacity of v-band clamp joints. [PDF]
, 2009 Band clamps with a flat bottomed V-section are used to connect a pair of circular flanges to provide a joint with significant axial strength. Despite the wide application of V-band clamps, their behaviour is not fully understood and the ultimate axial ...
Barrans, Simon, Muller, M
core +5 more sources
Predicting The Axial Load Of Capacity Of Joints Formed By V-Band Retainers [PDF]
V-band retainers are widely used in the automotive, aircraft and aerospace industries to connect a pair of circular flanges to provide a joint with good axial strength and torsional rigidity.
Blunt, Liam, Müller, M.
core +5 more sources
Impact of flange geometry on the ultimate axial load capacity of V-band clamps [PDF]
, 2010 Modern turbochargers typically comprise a body in three parts; the turbine and compressor housings and the bearing housing. The preferred method of joining these three parts, in automotive applications, is to use a band clamp with a flat bottomed V ...
Barrans, Simon, Muller, Matthias
core +5 more sources
Behavior of B-C connections damaged by thermal shock
Magazine of Civil Engineering, 2020 The behavior of beam-column (B-C) connections received thorough investigation during the past decades focusing on critically-detailed connections before and after strengthening. Exposure of such B-C connections to thermal shock due to subjected to cycles
Rajai Al-Rousan
doaj +1 more source
Kinematics of a cervical disc prosthesis implanted above or below one- and two-level fusions
North American Spine Society Journal, 2022 Background: The theoretical advantages of hybrid constructs over multi-level fusion have been illustrated in clinical and biomechanical studies. However, there is no biomechanical data on hybrid constructs using load control analyses.
Muturi G. Muriuki +5 more
doaj +1 more source
THE EFFECT OF VARIATION CONCRETE CUBE OF AXIAL LOAD ON ULTRASONIC PULSE VELOCITY TRANSMITTER
Journal of the Civil Engineering Forum, 2015 Nowadays, Non Destructive Tests have been applied in some quality evaluation of existing concretes on site. One of the Non Destructive Test (NDT) methods is the application of the Ultrasonic Pulse Velocity (UPV) method. In general, utilizations of UPV as
Faqih Ma’arif +2 more
doaj +1 more source
Pre-Load Effect on CFRP-Confinement of Concrete Columns: Experimental and Theoretical Study
Crystals, 2021 The axial compression strength of concrete columns has been proved to be significantly enhanced by external confinement. In this perspective, the use of Fiber-Reinforced Polymers (FRPs) has been extensively studied.
Francesco Micelli +2 more
doaj +1 more source
Instrumentation and Axial Load Testing of Displacement Piles [PDF]
, 2013 Despite the fact that results of many instrumented pile load tests have been reported in the literature, it is difficult to find well-documented instrumentation procedures that can be used when planning a load testing programme.
Salgado, Rodrigo +4 more
core +1 more source
Study on Noise Model of an Automotive Axial Fan Based on Aerodynamic Load Force
Applied Sciences, 2022 Due to the fact that the noise caused by axial fan blades of vehicles is large, which seriously affects ride comfort, and there is no effective mathematical model to quantitatively study the contribution of the various parameters of the blades to the ...
Yinhui Zhong, Yinong Li, Jun Li
doaj +1 more source
Medicina, 2023 Background: The objective of this study was to evaluate the load transmitted to the peri-implant bone by seven different restorative materials in single-unit rehabilitations with morse taper implants using a strain gauge.
Rafael Garcia Martins +4 more
doaj +1 more source