Results 191 to 200 of about 10,671 (243)

Characterization of rotary valve control vibration system for vibration stress relief applications. [PDF]

Sci Rep
Zhou G, Zhao G, Wang H.
europepmc   +1 more source

Study on the failure mechanism and improvement measures of bearings in the full-ocean-depth ultra-high-pressure seawater pump. [PDF]

Sci Rep
Chen Z, Hu X, Li L, Ye C, Wu D, Liu S, Ma Y, Gu L.   +7 more
europepmc   +1 more source

Nonlinear transient analysis of water lubricated bearing in the turbulent regime. [PDF]

Sci Rep
Mallya R, Pai R, Shenoy Baloor S.
europepmc   +1 more source

A Pneumatic Flexible Linear Actuator Inspired by Snake Swallowing. [PDF]

Adv Sci (Weinh)
Qi Y, Shao J, Zhao Y, Niu T, Yang Y, Zhong S, Xie S, Lin Y, Yang Y.   +8 more
europepmc   +1 more source

A Novel Fault Diagnosis Strategy for Diaphragm Pumps Based on Signal Demodulation and PCA-ResNet. [PDF]

Sensors (Basel)
Meng F, Shi Z, Song Y.
europepmc   +1 more source

Design and Fabrication of Biomimetic Gradient Bone Tissue Engineering Scaffolds: Evolution from Single-Gradient to Multi-Gradient. [PDF]

Gels
Liu H, Liu J, Sun C, Wang Y, Sun Y, Shi X.   +5 more
europepmc   +1 more source

Periodic Flows in Microfluidics. [PDF]

Small
Mudugamuwa A, Roshan U, Hettiarachchi S, Cha H, Musharaf H, Kang X, Trinh QT, Xia HM, Nguyen NT, Zhang J.   +9 more
europepmc   +1 more source

Role of critical stress in quantifying the magnitude of fluid-injection triggered earthquakes. [PDF]

Nat Commun
Yu J, Eijsink A, Marone C, Rivière J, Shokouhi P, Elsworth D.   +5 more
europepmc   +1 more source

A novel true triaxial apparatus for high-stress low-frequency disturbance in hard rocks: Development, validation, and application. [PDF]

PLoS One
Peng C, Jia H, Liu Y, Liu H, Zhang X.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Slipper Balance in Axial Piston Pumps and Motors

Journal of Tribology, 1992
The paper presents the results of an experimental and theoretical investigation of the effect of clamping ratio and orifice size on the performance of slippers in axial piston pumps and motors. Polishing of the running face to a slightly convex form appears to be essential for successful operation under all conditions. It is shown that slippers operate
Koc E., Hooke C.J., Li K.Y.
openaire   +1 more source