Results 161 to 170 of about 746 (182)

Interface formation in carbon fibre reinforced magnesium alloys (AZ91)

Journal of Materials Science Letters, 1995
In metal matrix composites the adhesion between a ceramic fibre and the metal matrix should be submitted on the atomic scale to physical or chemical forces, without forming a reaction zone [1, 2]. Only in this case will fibres remain undamaged and a load transformation from the fibre to the matrix take place during composite application.
Kleine, A.*, Hemptenmacher, J., Dudek, H.J., Kainer, K.U.**, Krueger, G.***   +4 more
openaire   +2 more sources

Cerium and Silane Conversion Coatings on AZ91 Magnesium Alloy

Advanced Materials Research, 2010
With different means of soaking treatment, simple cerium conversion coating, KH560 silane conversion coating, cerium silane conversion coating and silane cerium conversion coating are formulated. SEM, EDS, Tafel and EIS measurements were adopted as the analysis approaches, and organic resin is coated on the conversion coating surface for the salt spray
Yan Ling Lu, Shi Guo Du, Yi Guo, Yan Kun Chen, Qing Hong   +4 more
openaire   +1 more source

Creep behaviour of Deep Cryogenic Treated AZ91 Magnesium alloy

2012
The Deep Cryogenic Treatment (DCT) is known to havebeneficial effects on mechanical behavior/properties ofsome alloys. It was also reported to be beneficial for thecreep strength of Mg alloys. The present study is aimedat checking the effect of DCT on the high temperaturebehaviour of the Mg alloy AZ91 by means of comparativecreep tests at 100 and 200°C
GARIBOLDI, ELISABETTA, GE, QIANG, LECIS, NORA FRANCESCA MARIA, S. Spigarelli, M. El Mehtedi   +4 more
openaire   +5 more sources

Creep of Reinforced and Unreinforced AZ91 Magnesium Alloy

Key Engineering Materials, 1999
Václav Sklenička, M. Pahutová, K. Kuchařová, Milan Svoboda, Terence G. Langdon   +4 more
openaire   +1 more source

XPS study of the surface chemistry on AZ31 and AZ91 magnesium alloys in dilute NaCl solution

Applied Surface Science, 2010
Tadashi Shinohara
exaly  

Deformation Patterns in Tensile Loaded Polycrytalline Magnesium and AZ91 Alloy

The deformation mechanisms of FCC metals such as aluminium are well understood and documented. For HCP metals however, there is not as much information available. This is due to the complexity of HCP crystal deformation. In order to understand the mechanical properties of magnesium and its alloys, their deformation mechanisms must first be analysed ...
openaire   +2 more sources

An investigation on the tribological behavior of AZ91 and AZ91 + 3 wt% RE magnesium alloys at elevated temperatures

Materials & Design, 2014
Ahmad Zafari, Reza Mahmudi, H M Ghasemi   +2 more
exaly  

Characterisation of the rheological behaviour in the semi-solid state of grain-refined AZ91 magnesium alloys

Materials Science & Engineering A: Structural Materials: Properties, Microstructure and Processing, 1999
M Suéry
exaly  

Effect of minor Sc on the microstructure and mechanical properties of AZ91 Magnesium Alloy

Progress in Natural Science: Materials International, 2018
Fusheng Pan, Han Lin
exaly  

Corrosion protection of polypyrrole electrodeposited on AZ91 magnesium alloys in alkaline solutions

Synthetic Metals, 2003
Y H Wei
exaly