Results 31 to 40 of about 490 (132)
Overcoming Out‐of‐Plane Conduction by Changing Nanosheet Morphology
HTaWO6 membrane made of stacked nanotubes exhibits high out‐of‐plane proton conductivity of 1.7 mS/cm. High current density (1.26 A cm−2) and power density (294 mW cm−2) indicate the potential as a fuel‐cell electrolyte. The morphology‐driven strategy establishes topology engineering as a new design principle for efficient ion transport in two ...
Yuichi Sakuda +7 more
wiley +1 more source
Study on the process of preparing Al-Ce alloy by electrodeposition
The process of Al-Ce alloy prepared by electrodeposition was studied in molten LiF-KCl-CeF3 salt at 820 °C. Several process parameters such as back electromotive force and current efficiency were measured by continuous pulse oscillograph.
J. D. Li +6 more
doaj
Bio‐based gel polymer electrolytes promise sustainable, mechanically adaptable zinc–air batteries, yet their progress is constrained by inconsistent characterization. This review critically links formulation, structure, interfaces, and cell performance, identifies methodological gaps under alkaline operating conditions, and proposes application ...
Matteo Milanesi +6 more
wiley +1 more source
Multi physics field simulation analysis of different pole slots combined with automotive permanent magnet motors [PDF]
Aiming at the problems in the design of permanent magnet synchronous motor for vehicles, taking the 8-pole 48-slot and 8-pole 36-slot interior permanent synchronous motors as subject, the influence of different pole-slot combinations on the ...
Guohao LI +5 more
doaj +1 more source
Static eccentricity (SE) is frequently generated by manufacturing processes. As the nonuniformity of the air-gap length is caused by the SE, the torque ripple and cogging torque increase in the motor.
Jin-Cheol Park +5 more
doaj +1 more source
A volatile‐switching compact model of electrochemical metallization memory cells for neuromorphic architecture is developed and validated by reliable reproduction of device characterization measurements: I−V sweeps, SET kinetics, relaxation dynamics.
Rana Walied Ahmad +4 more
wiley +1 more source
Similar to armature back electromotive force (armature back-EMF), the back-EMF also exists in the field winding of hybrid excited machines. However, the existence of field back electromotive force (field back-EMF) is harmful to the safe and stable ...
Zhiyu Yang +5 more
doaj +1 more source
A Method to Improve Torque Density in a Flux-Switching Permanent Magnet Machine
With the continuous development of machines, various structures emerge endlessly. In this paper, a novel 6-stator-coils/17-rotor-teeth (6/17) E-shaped stator tooth flux switching permanent magnet (FSPM) machine is introduced, which has magnets added in ...
Junshuai Cao +5 more
doaj +1 more source
In the NFPF–NVPF heterostructure, the interfacial FeV 3d‐orbital coupling drives the upshifting of the d‐orbital and facilitates electron delocalization. This dual‐effect mechanism significantly expands the spatial distribution of electrons and narrows the bandgap, thereby constructing synergistic electron‐ion transport channels to achieve excellent ...
Yan Liu +11 more
wiley +1 more source
Fractional-slot winding permanent magnet motors(PM) are widely applied due to their unique advantages,with the most notable being their high-quality sinusoidal no-load back electromotive force(EMF) waveform.
ZHENG Junqiang; XU Haoen; ZHANG Yuting; MAO Jingfeng
doaj +1 more source

