Results 41 to 50 of about 151 (113)
Graphene-Based Plasmonic Tunable Dual-Band Bandstop Filter in the Far-Infrared Region
IEEE Photonics Journal, 2018 A tunable dual-band bandstop filter (BSF) in the far-infrared region is proposed based on a graphene surface plasmon. The BSF consists of a graphene waveguide and two graphene-ribbon resonators on the SiO2/Si substrate, supporting waveguide mode ...
Yijun Cai +4 more
doaj +1 more source
Alexandria Engineering Journal, 2023 Reduction of mutual coupling in the radiating elements of multiple input multiple output (MIMO) antenna is always an issue and a big challenge for antenna researchers.
Hashinur Islam +6 more
doaj +1 more source
7th order harmonic suppression and wide rejection band using CSRR backed BSF [PDF]
, 2019 To obtain the high rejection level for undesired band from a microstrip band pass filter, a complimentary split ring resonator (CSRR) backed bandstop filter (BSF) has been used at the input of bandpass filter.
Patel, Kamlesh ; Dept of Electronic Science, University of Delhi South Campus, New Delhi +3 more
core +5 more sources
Simulation of a Compact Dual-Band Microstrip Bandstop Filter [PDF]
, 2020 : A compact dual-band microstrip bandstop filter (BSF) is proposed. This filter combines a conventional two open stubs BSF and an optimum BSF. Simulations show this filter generates two stopbands around 2.52 GHz and 5.02 GHz without increasing the ...
S Yang
core
Applied Sciences, 2023 An ultra-wideband common-mode (CM) filter for a gigahertz (GHz) data rate signal is proposed in this paper. The proposed filter was designed only on the printed circuit board (PCB) ground plane; no additional components wererequired. We took advantage of
Ding-Bing Lin +3 more
doaj +1 more source
Compact Bandstop Filters with Extended Upper Passbands [PDF]
, 2008 This paper presents new compact bandstop filters (BSFs) with extended upper passbands. In the basic proposed filter configuration, the conventional quarter-wavelength open-stub resonators are replaced with equivalent two-section stepped impedance ...
Majeed A. S. Alkanhal, Alkanhal, M.A.S.
core +1 more source
Multiband Terahertz Self-Complementary Metasurface
IEEE Access, 2020 A self-complementary metasurface is presented for application in multiband terahertz filters. The unit cell structures of the self-complementary metasurface consist of a combination of an ordinary Jerusalem cross and its complementary counterpart that ...
Se-Mi Kim +4 more
doaj +1 more source
Inkjet-Printed Bandstop Filters for Interference Suppression in Multi-Standard Wireless Systems [PDF]
, 2016 This paper presents a highly compact inkjet printed microstrip bandstop filter (BSF) for interference suppression in multi-standard wireless applications.
Budimir, D. +3 more
core +1 more source
IET Microwaves, Antennas &Propagation, Volume 18, Issue 5, Page 308-316, May 2024.A novel wideband dual‐band bandstop filter (DBBSF) with multi‐transmission zeros (TZs) and multi‐reflection zeros (RZs) is presented. It consists of two pairs of symmetric open‐ended coupled lines at two sides and (2N–1) pairs of coupled‐line sections (CLSs) with an open‐circuited stub (OCS) in the middle.
Chang Xu +6 more
wiley +1 more source
Novel compact size bandstop filter with shorted-stub loaded ring resonator [PDF]
, 2011 A planar compact bandstop filter (BSF) and a miniaturized resonator structure are presented along with its analytical equation to obtain resonance.
ALONSO CORONA CHAVEZ +1 more
core