Results 91 to 100 of about 472,209 (346)

Four‐Point Bending Tests at High Temperatures on Commercial MgO‐C Refractory Bricks with and Without Recyclate Considering Different Carbon Contents

Advanced Engineering Materials, EarlyView.
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm, Lukas Knöchel, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +5 more
wiley   +1 more source

An Analysis of the Flexural Stiffness and Horizontal Bearing Capacity of CFRP Composite Pipe Piles in Marine Environments

Journal of Marine Science and Engineering
Carbon-fiber-reinforced polymer (CFRP) is a composite material consisting of a resin matrix reinforced with carbon fibers. This study focuses on CFRP composite pipe piles as the subject of investigation, exploring the impact of substituting steel bars ...
Wei Zhang, Wei Shao, Yinghui Nie
doaj   +1 more source

Mechanical performance of glass-based geopolymer matrix composites reinforced with cellulose fibers [PDF]

, 2018
Glass-based geopolymers, incorporating fly ash and borosilicate glass, were processed in conditions of high alkalinity (NaOH 10-13 M). Different formulations (fly ash and borosilicate in mixtures of 70-30 wt% and 30-70 wt%, respectively) and physical ...
Bernardo, Enrico, Dlouhy, Ivo, Taveri, Gianmarco   +2 more
core   +2 more sources

On‐Demand Activation of Thin Alginate Shell Encapsulated Volatile Liquid for Untethered Pneumatic Soft Actuation

Advanced Engineering Materials, EarlyView.
Phase‐changing liquids enable untethered pneumatic actuation in soft robotics but suffer from volatility and storage challenges. This work reports a simple method to encapsulate Novec 7000 within micron‐thin alginate shells via in situ injection and ionic crosslinking.
Rayan A. M. Basodan, Jack Keddie, Byoungyoul Park, Hyun‐Joong Chung   +3 more
wiley   +1 more source

Structural performance and mechanical properties investigation of spent nuclear fuel rods under static and dynamic bending loads

, 2021
Efstathios Vlassopoulos
openalex   +2 more sources

Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys

Advanced Engineering Materials, EarlyView.
This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa, Aparna Saksena, Alesander Kostka, Pascal Thome, Felicitas Scholz, Alexandre Mussi, Christoph Somsen, Baptiste Gault, Jan Frenzel, Gunther Eggeler   +9 more
wiley   +1 more source

Effect of annealing time on bending performance and microstructure of C19400 alloy strip

Nanotechnology Reviews
The effect of annealing time on the bending properties and microstructure of cold-rolled C19400 alloy was studied by transmission electron microscopy, scanning electron microscopy, and optical microscopy.
Zhang Yanmin, Huang Baohuan, Gao Hongjiao, Li Shanguang, Zhou Fei, Song Kexing   +5 more
doaj   +1 more source

Impact of Sustainable Binders Based on Lignin and Collagen on the Volume Stability and Mechanical Properties of MgO‐C Refractories with MgO‐C Recyclates

Advanced Engineering Materials, EarlyView.
Collagen hydrolysate is evaluated as a sustainable binder for MgO‐C refractories. Its thermally induced cross‐linking and gas release lead to expansion and cracking in large bricks, but tailored batches with lignin, recyclates, or fine graphite improve the gas release while thermal treatment and stability.
Till M. J. Stadtmüller, Florian Kerber, Kirsten Moritz, Steffen Dudczig, Konstantin Kraushaar, Thomas Schemmel, Jana Hubálková, Patrick Gehre, Christos G. Aneziris   +8 more
wiley   +1 more source

Research on the Bending Behavior of Concrete Beams Reinforced with CFRP Sheets Bonded Using BMSC

Buildings
To improve the construction performance of inorganic adhesives used for bonding fiber-reinforced polymer (FRP) sheets to reinforce concrete structures, make rational use of resources, and reduce carbon emissions, double-shear tests on the interface ...
Zhenzhong Yang, Lili Jiang, Zhenguo Li, Chenggen Yang   +3 more
doaj   +1 more source

Predictive Control for Alleviation of Gust Loads on Very Flexible Aircraft

, 2014
In this work the dynamics of very flexible aircraft are described by a set of non-linear, multi-disciplinary equations of motion. Primary structural components are represented by a geometrically-exact composite beam model which captures the large dynamic
Chen P., Goland M., Goland M., Géradin M., Géradin M., Maciejowski J. M., Rawlings J. B., Simpson R. J. S., Stevens B. L.   +8 more
core   +1 more source