Results 131 to 140 of about 1,707 (183)

Biaxial fatigue behavior of a polychloroprene rubber

International Journal of Fatigue, 2011
Understanding phenomenon induced by complex fatigue loadings is an important issue for the conception of industrial components. Rubber materials, thanks to their abilities to withstand high deformations, are more and more used in industry. In an ongoing study, an experimental investigation is being carried out to study the effect of multiaxial loadings
Poisson, Jean-Louis, Lacroix, Florian, Méo, Stéphane, Berton, Gaëlle, Ranganathan, Naranayaswami   +4 more
openaire   +1 more source

Biaxial Wheel Fatigue Test

2021
<div class="section abstract"> <div class="htmlview paragraph">This SAE Recommended Practice provides uniform laboratory procedures for biaxial fatigue testing of wheels intended for normal highway use and temporary use on passenger car vehicles and light trucks and minimum cycle requirement for ferrous wheels for ballasted passenger car ...
openaire   +1 more source

Simulation of the scenario of the biaxial wheel fatigue test

Advances in Engineering Software, 2017
Abstract This paper presents a new approach to the virtualization of the scenario of the biaxial wheel fatigue test. This test is the state-of-art and the standard requirement for the validation of vehicle wheels. During this test, tire and wheel specimens run inside an inner drum while standardized vertical and horizontal loads are applied.
Fabio M. Santiciolli, Riccardo Möller, Ivo Krause, Franco Giuseppe Dedini   +3 more
openaire   +1 more source

Biaxial Wheel Fatigue Test

2017
<div class="section abstract"> <div class="htmlview paragraph">This SAE Recommended Practice provides uniform laboratory procedures for biaxial fatigue testing of wheels intended for normal highway use and temporary use on passenger car vehicles and light trucks and minimum cycle requirement for ferrous wheels for ballasted passenger car ...
  +4 more sources

Biaxial Fatigue Testing Of Vulcanizates

Rubber Chemistry and Technology, 1961
Abstract Extensive fatigue tests of vulcanizates of natural rubber and SBR were carried out using a cycle of alternate stretching in two perpendicular directions. It is shown that the data can be best handled statistically by assuming a lognormal distribution or by the use of extreme probability techniques.
S. D. Gehman, P. Rohall, D. I. Livingston   +2 more
openaire   +1 more source

Biaxial tension fatigue response of concrete

Cement and Concrete Composites, 2003
Abstract Concrete structures such as rigid airport pavements are subjected to repeated high-amplitude loads resulting from passing aircraft. The resulting stress-state in concrete is a biaxial combination of compression and tension. It is of interest to understand the response of plain concrete to such loading conditions, which will enable ...
Kolluru V Subramaniam, Surendra P Shah
openaire   +1 more source

Biaxial impact fatigue of polycarbonate

Journal of Materials Science, 1982
An impact fatigue test has been designed for studying the repeated biaxial impact load response of polymers. In the test geometry, a thin plate-like sample is rigidly held by an annular clamp and is repeatedly impacted by a hemispherically-tipped plunger. Results have been obtained for polycarbonate.
openaire   +1 more source

Development of a biaxial fatigue testing rig

Journal of Strain Analysis, 1975
A biaxial fatigue testing rig which employs cruciform specimens loaded by four double-acting hydraulic cylinders has been improved by the addition of a closed-loop servo-control system. This system enables the loads or strains in the two principal directions to be varied independently of each other.
M W Parsons, K J Pascoe
openaire   +1 more source

Biaxial Fatigue Cracking from Notch

2013
Abstract : A study was initiated to clarify the behavior of biaxial fatigue cracking from a notch, transverse or 45 deg inclined, in a cruciform specimen of a 7075-T651 aluminum alloy. The biaxial fatigue test was conducted in air and aqueous 3.5% NaCl solution at room temperature under inphase and 180 deg out-of-phase loadings with biaxiality ratios ...
Charles Lei, Robert E. Taylor, Bruce A. Pregger, Eun U. Lee   +3 more
openaire   +1 more source

The Effect of Biaxial Stresses on Fatigue and Fracture

Journal of Engineering for Industry, 1970
The results are presented of an analytical and experimental program which was conducted to determine if a biaxial stress field produces a significant effect on the fatigue and fracture behavior of thin plates. The materials tested were 6061-T4 and 6061-T6 aluminum sheets and plexiglas sheets.
John J. Kibler, Richard Roberts
openaire   +1 more source