Results 121 to 130 of about 523 (177)

Comprehensive review of enhanced oil recovery strategies for heavy oil and bitumen reservoirs in various countries: Global perspectives, challenges, and solutions. [PDF]

Heliyon
Seidy-Esfahlan M, Tabatabaei-Nezhad SA, Khodapanah E.   +2 more
europepmc   +1 more source

Rehabilitation and reinforcement of cracked pavements using crack sealers and composite patches. [PDF]

Heliyon
Aliha MRM, Karimi HR, Khedri E, Abdipour SV, Haghighatpour PJ.   +4 more
europepmc   +1 more source

Preparation of Novel Slow-Release Acid Materials for Oilfield Development via Encapsulation. [PDF]

Materials (Basel)
Sun X, Chen C, Li M, Yao Y, Guo B, Xu J.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Suitability of Chitosan as an emulsifier for cationic bitumen emulsions and its behaviour as an additive to bitumen emulsion

Construction and Building Materials, 2016
Abstract Chitosan contains amine and amino groups which have the ability to generate cationic type surfactants when combined with H + ions. It has a high potential for use as a cationic emulsifier for negatively charged siliceous aggregates for paving of roads in Sri Lanka.
D.R. Mallawarachchi, A.D.U.S. Amarasinghe, M.A.B. Prashantha   +2 more
exaly   +2 more sources

Effect of Cement and Bitumen Emulsion on the Drying and Film Formation of Bitumen Emulsion Paste

Journal of Materials in Civil Engineering, 2023
Cao Peng, Jian Ouyang, Ouyang Jian
exaly   +2 more sources

Effect of process parameters on bitumen emulsions

Chemical Engineering and Processing: Process Intensification, 2005
Abstract Bitumen emulsification experiments have been carried out in a continuous pilot scale rotor-stator facility. The effects of the following process parameters, namely the temperature of the aqueous phase and bitumen, the rotor speed, the dispersed phase content, the bitumen grade and the emulsion flow rate were investigated.
Jean-Philippe Gingras, Philippe A. Tanguy, Sophie Mariotti, Pierre Chaverot   +3 more
openaire   +1 more source

Waterproofing latex-bitumen emulsions

Polymer Science. Series D, 2008
Bitumen emulsions are developed based on new anionic emulsifiers, which are wastes of chemical industry. Optimal concentrations of emulsifiers in bitumen emulsions are established. The developed bitumen emulsions are not inferior in their process and service parameters to known domestic and foreign analogs.
M. A. Nuriev, A. V. Murafa, D. B. Makarov, V. G. Khozin   +3 more
openaire   +1 more source

Electrical properties of bitumen emulsions

Fuel, 1995
The complex dielectric constant (permittivity) of water-in-bitumen emulsion was measured for emulsions with water volume fractions ranging from 0 to 0.5, in steps of 0.1. Significant departure from theoretical calculation was observed, and was attributed to the presence of polar components in the bitumen.
Sowa, J.M., Sheng, Ping, Zhou, Minyao, Chen, T., Serres, Anita J., Sieben, M.C.   +5 more
openaire   +2 more sources

The combustion of bitumen-in-water emulsions

Fuel, 1991
Abstract The combustion behaviour of bitumen-in-water emulsions has been investigated using suspended and falling droplet techniques together with some experiments of spray combustion using an air blast atomizer. Single droplet measurements have been made using a commercial soft bitumen-in-water emulsion (Orimulsion) and similar mixtures with varied ...
N. Marcano, M. Pourkashanian, A. Williams   +2 more
openaire   +1 more source