Results 31 to 40 of about 8,894 (300)
Non-axisymmetric turbine end wall profiling [PDF]
, 2001 A design method for profiling the end wall to reduce secondary flow has been reported previously. A profile has been tested in the Durham Linear Cascade and the results confirmed the design method.
Harvey, NW. +4 more
core +1 more source
An investigation of secondary flow in a turbine blade with end wall profiling [PDF]
, 1999 Secondary flows have been long recognised as a significant form of loss mechanism in turbomachinery. They have a major influence over the performance of the blade rows since they cause unsteadiness in the mainstream flow.
Jayaraman, Punitha
core
FEBS Open Bio, EarlyView.Unique biological samples, such as site‐specific mutant proteins, are available only in limited quantities. Here, we present a polarization‐resolved transient infrared spectroscopy setup with referencing to improve signal‐to‐noise tailored towards tracing small signals. We provide an overview of characterizing the excitation conditions for polarization‐
Clark Zahn, Karsten Heyne
wiley +1 more source
Dynamics of Chloroplast Translation during Chloroplast Differentiation in Maize. [PDF]
PLoS Genetics, 2016 Chloroplast genomes in land plants contain approximately 100 genes, the majority of which reside in polycistronic transcription units derived from cyanobacterial operons.
Prakitchai Chotewutmontri, Alice Barkan
doaj +1 more source
Endwall profiling for the reduction of secondary flow in turbines [PDF]
, 2003 This thesis describes investigations into the use of a technique for improving the efficiency of axial flow turbines. The flow in the turbine component of axial flow machines is complex, with a number of three-dimensional features.
Ingram, Grant Laidlaw, Ingram, Grant
core
Aerodynamic improvement of GTE compressors by space profiling of blade vanes
, 2013 The optimum spatial profiling of blade vanes of GTE compressor stages is considered on the basis of calculation of a three-dimensional viscid stream.
V. P. Gerasimenko, M. Y. Shelkovsky
core +1 more source
Advanced Engineering Materials, EarlyView.This study explored how effective nickel aluminide coatings are obtained in providing oxidation resistance applied to the Inconel 738 alloy, modeling with diffusion models. In the present study, kinetics and thermal behavior of the Inconel 738 alloy were studied by the low‐temperature thermoreactive aluminizing process, which was carried out at 625°C ...
Gozde Celebi Efe +4 more
wiley +1 more source
Design and Experimental Validation of the Profiling Cutting Platform for Tea Harvesting
AgricultureThe low quality of mechanized tea harvesting in China’s hilly plantations, often caused by irregular canopy morphology, necessitates improved technology. This study addresses this issue by proposing a contact-based profiling mechanism and a corresponding
Hang Zheng +5 more
doaj +1 more source
The Application of Non-Axisymmetric Endwall Contouring in a 1½ Stage, Rotating Turbine [PDF]
, 2011 Today gas turbines are a crucial part of the global power generation and aviation industries. Small improvements to the efficiencies of individual components within the gas flow path can, over time, lead to dramatic cost savings for the operator and at ...
SNEDDEN, GLEN,CAMPBELL +1 more
core
Metabolomics analysis reveals tissue-specific metabolite compositions in leaf blade and traps of carnivorous Nepenthes plants [PDF]
, 2020 Nepenthes is a genus of carnivorous plants that evolved a pitfall trap, the pitcher, to catch and digest insect prey to obtain additional nutrients. Each pitcher is part of the whole leaf, together with a leaf blade.
Carlos E. Rodríguez-López +7 more
core +1 more source