Energies, 2023 Due to the uneven temperature field and temperature gradient introduced by an efficient cooling structure, the analysis of the stress field is necessary. In this study, the cooling characteristics and stress characteristics such as the thermal stress and
Haiwang Li +4 more
doaj +1 more source
Film Cooling From Two Staggered Holes Rows of Opposite Injection Angles with Downstream Row Embedded In Arc Trench [PDF]
Engineering and Technology Journal, 2014 Experimental investigation of film cooling from two staggered rows holes,backward and forward; of opposite injection angles has been done. The forward holes row was embedded in arc trench.
Assim H Yousif, Humam Kareem Jalghaf
doaj +1 more source
Influence of different blowing parameters on flow control on an airfoil
Journal of Mechanical Engineering and Sciences, 2022 A numerical study on flow separation control is conducted for an airfoil with a blowing jet. In this regard, the effect of different parameters of air blowing on stall controlling and flow structure over NACA 0012 is followed.
S. Abbasi
doaj +1 more source
A Transient Method Using Liquid Crystal for Film Cooling Over a Convex surface
International Journal of Rotating Machinery, 2001 In order to explore the effect of blowing ratio on film cooling over a convex surface, the present study adopts the transient liquid crystal thermography for the film cooling measurement on a straight circular hole configuration.
Ping-Hei Chen +2 more
doaj +1 more source
Numerical Simulation of the Slag Splashing Process in A 120 Ton Top-Blown Converter
Metals, 2023 Slag splashing operations at the end of the converter blow process can improve the furnace liner life and the converter operation rate. However, the effect of factors on slag splashing at actual dimensions is yet to be fully understood.
Guang Yang +4 more
doaj +1 more source
Local Heat Transfer Measurements on a Rotating Flat Blade Model with a Single Film Hole [PDF]
, 2009 An experimental study was performed to measure the heat transfer coefficient distributions on a flat blade model under rotating operating conditions. A steady-state thermochromic liquid crystal technique was employed to measure the surface temperature ...
Tao, Z +4 more
core +2 more sources
Experimental Study of Two Rows Hybrid Film Cooling Holes Over Flat Plate Surface Using IR Technology
Journal of Techniques, 2023 The study examines the effectiveness of two rows of hybrid film cooling holes over a plate surface using infrared technology and a thermal wind tunnel.
Ahmed A. Naji +3 more
doaj +1 more source
Air recovery assessment on high-pressure pneumatic systems [PDF]
, 2016 A computational simulation and experimental work of the fluid flow through the pneumatic circuit used in a stretch blow moulding machine is presented in this paper.
Codina Macià, Esteban +2 more
core +2 more sources
The Effect of Using Ramps with Trench Cylindrical Holes on Film Cooling Effectiveness
Wasit Journal of Engineering Sciences, 2015 The effect of introducing ramp with a cylindrical slot hole on the film cooling effectiveness has been investigated experimentally and numerically. The film cooling effectiveness measurements are obtained experimentally.
Ahmed A. Imram +2 more
doaj +1 more source
Control of rotorcraft retreating blade stall using air-jet vortex generators [PDF]
, 2006 A series of low-speed wind tunnel tests were carried out on an oscillating airfoil fitted with two rows of air-jet vortex generators (AJVGs). The airfoil used had an RAE 9645 section and the two spanwise arrays of AJVGs were located at x/c=0.12 and 0.62.
Akanni S. D. +22 more
core +1 more source