Results 231 to 240 of about 288,170 (305)

The genetic etiology of body fluids on chronic obstructive airways disease. [PDF]

open access: yesRespir Res
Cheng ZJ   +11 more
europepmc   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

open access: yesAdvanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal   +3 more
wiley   +1 more source

Nanostructured Affinity Membrane to Isolate Extracellular Vesicles from Body Fluids for Diagnostics and Regenerative Medicine. [PDF]

open access: yesMembranes (Basel)
Torsello M   +6 more
europepmc   +1 more source

Defect Evolution and Mechanical Performance of Fused Filament Fabrication‐Manufactured 17‐4PH Stainless Steel Revealed by X‐Ray Computed Tomography

open access: yesAdvanced Engineering Materials, EarlyView.
X‐ray computed tomography reveals how process‐induced defects evolve from green to sintered states in Fused Filament Fabrication (FFF)‐manufactured 17‐4PH stainless steel. Internal porosity, weakest cross‐sections, and fracture locations show strong correlation with tensile performance, demonstrating the potential of computed tomography (CT)‐based ...
György Ledniczky   +3 more
wiley   +1 more source

Stretching the Printability Metric in Direct‐Ink Writing with Highly Extensible Yield‐Stress Fluids

open access: yesAdvanced Functional Materials, EarlyView.
This study introduces “drawability” as a new metric for assessing printability in direct‐ink writing, focusing on gap‐spanning performance and speed robustness. By designing yield‐stress fluids with high extensibility, we demonstrate that extensional strain‐to‐break significantly enhances printability.
Chaimongkol Saengow   +9 more
wiley   +1 more source

From Food to Power: Hydrogel Thermoelectrics for Ingestible Electronics

open access: yesAdvanced Functional Materials, EarlyView.
We introduce a fully edible thermoelectric–electrochromic platform that harvests heat from food and converts it into a visible color change. N‐type and p‐type hydrogel thermoelectric generators connected in series power anthocyanin‐based electrochromic displays, demonstrating the feasibility of safe, biodegradable, ingestible systems for on‐food ...
Antonia Georgopoulou   +3 more
wiley   +1 more source

Multi-cancer Detection Using Pattern Formation in Drying Body Fluids: A Systematic Review and Meta-Analysis of Diagnostic Test Accuracy Studies. [PDF]

open access: yesTechnol Cancer Res Treat
Kokornaczyk MO   +10 more
europepmc   +1 more source

Human Gut Bacteria and Lipidic Nanoparticles: Particle Composition Predicts Structural Transformation and Bacterial Biocompatibility

open access: yesAdvanced Functional Materials, EarlyView.
Lipidic nanoparticles (LNPs) were incubated with 21 gut bacteria frequently associated with the human microbiome. SAXS revealed that ∼75% of tested species induced structural transformations in monoolein LNPs, whereas phytantriol and phospholipid formulations remained unaffected.
Jonathan Caukwell   +7 more
wiley   +1 more source

Clinical utility of multiplex PCR in the detection of pathogens from sterile body fluids. [PDF]

open access: yesJ Clin Microbiol
Cox CR   +5 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy