Results 21 to 30 of about 691 (197)
A new class of hybrid AC/AC direct power converters [PDF]
Variable voltage and variable frequency conversion of electrical energy from an AC source to an AC load is done in traditional power converters via a DC-link where an energy storage element (electrolytic capacitors) is situated.
Klumpner, Christian +2 more
core +4 more sources
This paper presents a newly designed modified multiport interleaved flyback converter (MMPIFC) to transfer the photovoltaic (PV) power to the DC bus of the parallel-connected multilevel inverter-based shunt active power filter (SHAPF).
Radhamani Rajakkannu +1 more
doaj +1 more source
Large-signal input characteristics of selected DC–DC switching converters, Part II. Discontinuous conduction mode [PDF]
Large-signal input characteristics of three DC–DC converter types: buck, boost and flyback working in the discontinuous conduction mode (DCM), obtained by precise large signal PSpice simulations, calculations based on averaged models and measurements are
Włodzimierz Janke +3 more
doaj +1 more source
An Active-Clamp Forward Inverter Featuring Soft Switching and Electrical Isolation
Traditional photovoltaic (PV) grid-connection inverters with sinusoidal pulse-width modulation (SPWM) control suffer the problem of buck-typed conversion.
Chien-Hsuan Chang +3 more
doaj +1 more source
Isolated Flying Capacitor Multilevel Converters
This paper presents the topology known as the isolated flying capacitor multilevel flyback converter (FCMFC). The topology uses isolated flying capacitors (FC) for high-gain, DC-DC power conversion while maintaining primary-secondary isolation and ...
Santino F. Graziani +2 more
doaj +1 more source
Elimination of an Electrolytic Capacitor in AC/DC Light-Emitting Diode (LED) Driver With High Input Power Factor and Constant Output Current [PDF]
published_or_final_versio
Chen, W, Hui, SYR
core +1 more source
Bidirectional Tapped-inductor Boost-Flyback Converter
This paper proposes a new bidirectional DC–DC converter with high efficiency. The proposed converter is composed of a flyback and a tapped-inductor boost converter to satisfy extreme operating conditions with low cost. The outputs are connected in series to achieve a high-voltage step-up.
Hyun-Woo Kim +3 more
openaire +2 more sources
The paper treats about main problems of one phase DC-AC microinverters that allow single solar cell to be joined with the grid. One of the issues is to achieve high voltage gain with high efficiency in DC circuit, which is necessary for proper operation ...
Kawa Adam +2 more
doaj +1 more source
In this paper the investigation results of a boost Flyback convert-er, which is used in a micro-inverter, are presented. The efficien-cy characteristics of the converter at various carrier frequencies and output loads were investigated.
Edvardas Bielskis +2 more
doaj +1 more source
Methodology for reducing the filtering capacitor in low-flicker LED drivers
The amount of light flicker in an AC–DC light-emitting diode (LED) driver is dependent on the size of filter capacitors. In this study, a study is conducted on reducing the size of filter capacitor in an AC–DC buck–boost/flyback LED driver using flicker ...
Ali Shagerdmootaab, Mehrdad Moallem
doaj +1 more source

