Developed Quasi Z-Source Inverters Based on Diode-Cells: Analysis and Implementation [PDF]
In this paper, two new developed quasi Z-source inverters (QZSI) based on two new diode-cells are proposed. The proposed inverters are called continuous diode assisted quasi Z-source inverter (CDQAZSI) and discontinuous diode assisted quasi Z-source ...
Sara Laali, Ebrahim Babaei
doaj +1 more source
Improved Symmetric Switched-Inductor/Capacitor Quasi Z-Source Inverter with Ability Uplifted-Boost [PDF]
This paper proposes a topology of switched-inductor/capacitor quasi z-source inverter (SIC-qZSI), which based on the classic qZSI. This topology is symmetric and has a high boost factor in the low duty cycle and high modulation index.
Alireza Karbalaei, Mohammad Mardaneh
doaj +1 more source
A new topology of the switched-inductor/capacitor quasi Z-source inverter with ability of uplifted-boost [PDF]
In this paper, a new topology of switched-inductor/capacitor quasi impedance source inverter is suggested, which in comparison with the other topologies possesses higher boost voltage inversion at high modulation index and low shoot through duty cycle ...
Alireza Karbalaei +2 more
doaj +1 more source
An Embedded Half-Bridge Γ-Z-Source Inverter with Reduced Voltage Stress on Capacitors
In this paper, an embedded half-bridge Z-source inverter based on gamma structure is proposed. In contrast with the classical half-bridge inverter, the proposed inverter can generate zero voltage levels in output. High voltage gain and low voltage stress
Hamed Mashinchi Maheri +5 more
doaj +1 more source
Enhanced Boost Factor for Three-Level Quasi-Switched Boost T-Type Inverter
A new modulation strategy has been introduced in this paper in order to enhance the boost factor for the three-level quasi-switched boost T-type inverter (3L-qSBT2I).
Duc-Tri Do +2 more
doaj +1 more source
Boost power factor correction converter with adaptive harmonic compensation control
In low‐voltage distribution systems, the increased penetration of power electronic devices leads to the decentralization of harmonic sources, which puts the sensitive loads or communication systems in the risk status. The conventional methods of point‐to‐
Rongfei Zhang +4 more
doaj +1 more source
Design and Implementation of Single-Phase Boost PFC Converter
In this paper, a single-phase boost type ac-dc converter with power factor correction (PFC) technique is designed and implemented. A current mode control at a constant switching frequency is used as a control strategy for PFC converter.
Jafar H. Alwash +2 more
doaj +1 more source
Sliding-mode control (SMC) is a robust technique used in power electronics (PE) for controlling the behavior of power converters. This paper presents simulations and experimental results of an optimal SMC strategy applied to Semi-Bridgeless Boost ...
José R. Ortiz-Castrillón +5 more
doaj +1 more source
Control and Design of a Boost-Based Electrolytic Capacitor-Less Single-Phase-Input Drive
Adjustable-speed drives with single-phase input require a power factor correction front-end, usually implemented by a boost converter, to reduce the current distortion from the uncontrolled rectifier; this stage is then followed by a three-phase inverter.
Alex Musetti +2 more
doaj +1 more source
DESIGN AND SIMULATION OF POWER FACTOR CORRECTION FOR AC/DC CONVERETER
One of the biggest problems in power quality aspects is the harmonic contents in the electrical system. Most of the current harmonics are due to the nonlinear operation of the power converters and arc furnaces .
Amina Mahmoud Shaker +2 more
doaj +1 more source

