Results 61 to 70 of about 22,321 (314)
To study the pile-forming mechanism and bearing deformation characteristics of continuous flight auger (CFA) piles, a series of procedures, including helical drilling, pulling up/grouting, and inserting cage/pile forming, were simulated in clay-sand ...
Deliang Zhu +4 more
doaj +1 more source
Prediction of vertical bearing capacity of waveform micropile [PDF]
This study proposes a predictive equation for bearing capacity considering the behaviour characteristics of a waveform micropile that can enhance the bearing capacity of a conventional micropile.
Han, J.-T. +3 more
core +1 more source
Multicolor optoelectronic synapses are realized by vertically integrating solution‐processed MoS2 thin‐film and SWCNT. The electronically disconnected but interactive MoS2 enables photon‐modulated remote doping, producing a bi‐directional photoresponse.
Jihyun Kim +8 more
wiley +1 more source
Technology of formation of the widened basis under bored piles and the device for its realization
The device for formation of the expanded basis under bored piles and technology of its performance is presented. It is shown, that increase of bearing ability of a pile of an offered build is reached by that at insertion of a trunk semiflexible blades ...
Н Aleksandrovna Stashevskaya +4 more
doaj
The interpretation methods used to predict ultimate pile capacity from load-settlement curves yield varied results due to their unique assumptions and limitations.
Usman Hasan Jalali +7 more
doaj +1 more source
Experimental Study on Post Grouting Bearing Capacity of Large Diameter Bored Piles
Post grouting can improve the inherent defects such as the formation of the mud cake at pile side and the sediment at pile end in the process of bored pile construction. Thus post grouting has been widely used in Engineering. The purpose of this paper is
Wang Duanduan +2 more
doaj +1 more source
The parameters of drilling boreholes (including depth, diameter, angle of borehole inclination, cross-section) that are currently used for the making bored piles under the conditions of dense urban area, have been considered.
M. O. Neplevksy
doaj +1 more source
Cross‐linked binders with enhanced resiliencies under low operating pressures are designed via in situ thiol‐ene click reactions within slurries. Cross‐linking improves the Young's moduli and elasticities of the styrene‐butadiene rubber binders, effectively mitigating interparticle delamination within the composite cathodes induced by volumetric ...
Young Joon Park +9 more
wiley +1 more source
Two‐Dimensional Materials as a Multiproperty Sensing Platform
Various sensing modalities enabled and/or enhanced by two‐dimensional (2D) materials are reviewed. The domains considered for sensing include: 1) optoelectronics, 2) quantum defects, 3) scanning probe microscopy, 4) nanomechanics, and 5) bio‐ and chemosensing.
Dipankar Jana +11 more
wiley +1 more source
Methods for karst hazard forecast and pipeline protection in South Yakutia [PDF]
The objective of this paper is to consider the ways of monitoring and protecting the pipeline "The Power of Siberia" from karst hazards. The method of protection with bored piles has been recommended and the forecasting methods have been overviewed. Thus,
Strokova, Ludmila Aleksandrovna +1 more
core +1 more source

