Results 81 to 90 of about 485,302 (167)

Embedded finite-element solver for computation of brushless permanent-magnet motors [PDF]

, 2008
This paper describes the theory underlying the formulation of a “minimum set” of finite-element solutions to be used in the design and analysis of saturated brushless permanent-magnet motors.
McGilp, M.I., Miller, T.J.E., Davies, A., Cossar, C., Olaru, M., Sturgess, J., Popescu, M., Sitzia, A.   +7 more
core   +1 more source

Brushless doubly-fed reluctance machine modeling, desing and optimization [PDF]

, 2015
Tese (doutorado) - Universidade Federal de Santa Catarina, Centro Tecnológico, Programa de Pós-Graduação em Engenharia Elétrica, Florianópolis, 2015.Esta tese aborda a modelagem, o projeto e a otimização, com validação experimental, de máquinas de ...
Staudt, Tiago
core  

General modeling of the windings for multi-phase ac machines [PDF]

, 2010
This paper, which deals with the winding modeling of ac multi-phase machines with a regular distribution of the stator slots, details an original matrix modeling of the stator winding.
CHARPENTIER, Jean-Frederic, SCUILLER, Franck, E. Semail, J.-F. Charpentier, SEMAIL, Eric, Semail, E., F. Scuiller, Scuiller, F., Charpentier, J.-F.   +8 more
core   +1 more source

A Vectorial Approach for Generation of Optimal Current References for Multiphase Permanent-Magnet Synchronous Machines in Real Time [PDF]

, 2011
This paper deals with the generation of optimal current references for multiphase permanent-magnet (PM) synchronous machines in normal or fault mode (open-circuited phases).
KESTELYN, Xavier, SEMAIL, Eric, Eric Semail, Xavier Kestelyn   +3 more
core   +1 more source

Axial flux permanent magnet machines for direct drive applications [PDF]

, 2007
This thesis explores aspects of the design, analysis, and experimental test of permanent magnet axial flux machines for use in diesel engine generator sets, vertical axis wind turbines, and wheel motors for solar cars.
Martin, Richard
core  

Design optimization of a slotless PM brushless motor with spiral wound laminations for rim driven thrusters

, 2009
This paper discusses the analysis and design of a very thin slotless PM brushless motor whose stator laminations are manufactured from a single strip of steel that is edge wound into a spiral (like a “Slinky”) and then fitted over the windings that are ...
Sharkh, S.M., Lai, S.H.
core   +2 more sources

Contactless Rotor Ground Fault Detection Method for Brushless Synchronous Machines Based on an AC/DC Rotating Current Sensor. [PDF]

Sensors (Basel), 2023
Pardo-Vicente MA, Guerrero JM, Platero CA, Sánchez-Férnandez JA.   +3 more
europepmc   +1 more source

Modelagem, projeto e análise de máquinas assíncronas trifásicas duplamente alimentadas sem escovas [PDF]

, 2006
Tese (doutorado) - Universidade Federal de Santa Catarina, Centro Tecnológico. Programa de Pós-Graduação em Engenharia Elétrica.Dentro do universo de máquinas elétricas girantes, a máquina assíncrona trifásica é a mais amplamente empregada nos ...
Rüncos, Fredemar
core  

Excitation Control of Brushless Induction Excited Synchronous Motor with Induction Machine Operating in Deep-Plugging Mode

Power Electronics and Drives
The popularity of electrified transportation is rising at a sharp pace due to environmental concerns over internal combustion (IC) engines. Researchers are nowadays looking for a brushless and permanent magnet (PM)-less solution for electric vehicle (EV)
Mondal Amit Kumar, Basak Saptarshi, Chakraborty Chandan   +2 more
doaj   +1 more source

Structurally Integrated Slotless PM Brushless Motor with Spiral Wound Laminations for Marine Thrusters

, 2006
Rim driven thrusters with structurally integrated brushless PM motors are now an established technology with an increasing range of applications. In these thrusters, the stator of the motor is housed within the thruster duct, and the rotor forms a ring ...
Lai, Shu, Abu-Sharkh, Suleiman
core   +1 more source