Results 61 to 70 of about 4,167,890 (151)

Hierarchical bubble size distributions in coarsening wet liquid foams. [PDF]

Proc Natl Acad Sci U S A, 2023
Galvani N, Pasquet M, Mukherjee A, Requier A, Cohen-Addad S, Pitois O, Höhler R, Rio E, Salonen A, Durian DJ, Langevin D.   +10 more
europepmc   +1 more source

In situ measurements of void fractions and bubble size distributions in bubble curtains. [PDF]

Exp Fluids, 2023
Beelen S, van Rijsbergen M, Birvalski M, Bloemhof F, Krug D.   +4 more
europepmc   +1 more source

Bubble formation from a flexible hole submerged in an inviscid liquid [PDF]

, 2003
In the waste water treatment industry, a novel gas sparger based on flexible membranes has been used for the last ten years. The objective of the present work is to study the bubble formation generated from a flexible orifice (membrane).
Hebrard, Gilles, Loubière, Karine
core   +1 more source

Effect of bubble size on ultrasound backscatter from bubble clouds in the context of gas kick detection in boreholes. [PDF]

Sci Rep, 2023
Indimath S, Fiorentini S, Bøklepp BR, Avdal J, Johansen TF, Måsøy SE.   +5 more
europepmc   +1 more source

End-to-End Bubble Size Distribution Detection Technique in Dense Bubbly Flows Based on You Only Look Once Architecture. [PDF]

Sensors (Basel), 2023
Chen M, Zhang C, Yang W, Zhang S, Huang W.   +4 more
europepmc   +1 more source

CFD-PBM Simulation on Bubble Size Distribution in a Gas-Liquid-Solid Flow Three-Phase Flow Stirred Tank. [PDF]

ACS Omega, 2022
Li S, Yang R, Wang C, Han H, Shen S, Wang H.   +5 more
europepmc   +1 more source

Effect of surfactants on liquid side mass transfer coefficients [PDF]

, 2005
In the present paper, the effect of liquid properties (surfactants) on bubble generation phenomenon, interfacial area and liquid side mass transfer coefficient was investigated.
Hebrard, Gilles, Loubière, Karine, Roustan, Michel, Mietton-Peuchot, Martine, Painmanakul, Pisut   +4 more
core   +1 more source

Hydrodynamic characteristics of the microbubble dissolution in water using an ejector-type bubble generator

Case Studies in Chemical and Environmental Engineering
This research uses an ejector bubble generator to determine water's flow structure and dissolved oxygen. The horizontal position of ejector, modified from conventional venturi, utilizes a gradual reduction in cross-section at the water inlet and contains
I.G.N.B. Catrawedarma, Sefri Ton, Dadang Dwi Pranowo, Fredy Surahmanto   +3 more
doaj   +1 more source

Prediction of Bubble Size Distributions in Large-Scale Bubble Columns Using a Population Balance Model

Computation, 2019
A precise estimation of the bubble size distribution (BSD) is required to understand the fluid dynamics in gas-liquid bubble columns at the “bubble scale,” evaluate the heat and mass transfer rate, and support scale-up approaches.
Giorgio Besagni, Fabio Inzoli
doaj   +1 more source

Insight into the impact of excluding mass transport, heat exchange and chemical reactions heat on the sonochemical bubble yield: Bubble size-dependency. [PDF]

Ultrason Sonochem, 2021
Dehane A, Merouani S, Hamdaoui O, Alghyamah A.   +3 more
europepmc   +1 more source