Circuit Configurable Bidirectional DC-DC Converter for Retired Batteries
Due to the rapid development and widespread usage of Electric Vehicles (EVs), there will be more and more retired batteries in the future. These retired batteries can be used in energy storage systems to stabilize smart grid operation with high ...
Jenhao Teng +3 more
doaj +1 more source
Extended Analysis of Non-Isolated Bidirectional High Gain Converter
This paper focuses on developing a non-isolated bidirectional high gain converter suited for EV charging. This converter has two ports with bidirectional features which functions in both buck and boost operation.
ANJANA, E., RAMAPRABHA, R.
doaj +1 more source
Pengembangan Model Boost-Buck untuk Mempertinggi Stabilitas Tegangan Keluaran Konverter DC-ke-DC
— This paper presented a novel boost-buck converter to provide the DC-DC converter. The converter consists of a cascaded configuration of the boost and buck converter.
Freddy Kurniawan

doaj +1 more source
DESIGN AND SIMULATION OF POWER FACTOR CORRECTION FOR AC/DC CONVERETER
One of the biggest problems in power quality aspects is the harmonic contents in the electrical system. Most of the current harmonics are due to the nonlinear operation of the power converters and arc furnaces .
Amina Mahmoud Shaker +2 more
doaj +1 more source
Comparison of load resistor and battery on controlling buck boost converter using fuzzy-pi method [PDF]
This paper discusses about controlling the buck boost converter output voltage remains constant by comparing of loads resistor and battery. Buck boost converter output voltage tends to be unstable when given a disturbance with a variety of loads, for ...
Massarang Maryanto +4 more
doaj +1 more source
A Reconfigurable Buck, Boost, and Buck-Boost Converter: Unified Model and Robust Controller [PDF]
The need for reconfigurable, high power density, and low-cost configurations of DC-DC power electronic converters (PEC) in areas such as the transport electrification and the use of renewable energy has spread out the requirement to incorporate in a single circuit several topologies, which generally result in an increment of complexity about the ...
Martín Antonio Rodríguez Licea +4 more
openaire +2 more sources
Microcontroller based bidirectional buck–boost converter for photo-voltaic power plant
A common configuration for a stand-alone PV power system may consist of three converters: a buck converter for the PV panel to charge the battery, a boost converter for the battery to discharge to the load and one for the load voltage regulation.
Viswanatha V., Venkata Siva Reddy R.
doaj +1 more source
A high efficiency non-inverting multi device buck-boost DC-DC converter with reduced ripple current and wide bandwidth for fuel cell low voltage applications [PDF]
The voltage produced by the fuel cell (FC) device is unregulated and varies from 0.4 V to 0.8 V on full load to no-load respectively. When these devices are used in low voltage applications and output voltage lies between higher and lower values of input
Venkatesh Naik M., Samuel Paulson
doaj +1 more source
Topology and Control Strategy of PV MVDC Grid-Connected Converter with LVRT Capability
This paper proposes an isolated buck-boost topology and control strategy for the photovoltaic (PV) medium-voltage DC (MVDC) converter with low-voltage ride through (LVRT) capability.
Huan Wang +4 more
doaj +1 more source
A Proposed Three-Phase Induction Motor Drive System Suitable for Golf Cars
In this paper, a proposed electric drive system for a three-phase induction motor is presented. The proposed drive system is suggested for a golf car as one type of electric vehicle.
Mohamed S. Elrefaey +5 more
doaj +1 more source

