Results 91 to 100 of about 129,057 (230)
Benefits and Challenges of Model-based Software Engineering: Lessons Learned based on Qualitative and Quantitative Findings [PDF]
Even though Model-based Software Engineering (MBSwE) techniques and Autogenerated Code (AGC) have been increasingly used to produce complex software systems, there is only anecdotal knowledge about the state-of-thepractice.
Goseva-Popstojanova, Katerina +2 more
core +1 more source
Arthritis Care &Research, Accepted Article.Objectives This study aimed to investigate hand function trajectories over 5 years in primary hand osteoarthritis. Additionally, determinants of baseline and longitudinal hand function were assessed. Methods 538 patients with both baseline and 5‐year study visits were analyzed.
Annemiek V.E.M. Olde Meule +4 more
wiley +1 more source
Arthritis Care &Research, EarlyView.Objective Hydroxychloroquine (HCQ) is a cornerstone therapy in systemic lupus erythematosus (SLE), but the weight‐based dosing does not account for clinical factors that can introduce individual variability in drug metabolism and clearance. We leveraged longitudinal data from a prospective SLE cohort to identify clinical factors that predict ...
Jay J. Patel +6 more
wiley +1 more source
Concurrency bugs in open source software: a case study
Journal of Internet Services and Applications, 2017 Concurrent programming puts demands on software debugging and testing, as concurrent software may exhibit problems not present in sequential software, e.g., deadlocks and race conditions.
Sara Abbaspour Asadollah +3 more
doaj +1 more source
Arthritis Care &Research, Accepted Article.Objective Studies of damage accrual in patients with systemic lupus erythematosus (SLE) show associations with disease activity measured by the SLE Disease Activity Index 2000 (SLEDAI‐2K), but these associations are imperfect. SLEDAI scores are powerfully influenced by weightings (1‐8) assigned to each domain.
Kevin Zhang +8 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Bug Localization for Version Issues With Defect Patterns
IEEE Access, 2019 Version issues are becoming more and more prominent with the continuous development of software. Bug localization for version issues is time-consuming and labor-intensive.
Xiaobing Sun +4 more
doaj +1 more source
Subbotools User's Manual [PDF]
The SUBBOTOOLS package is intended as an help to the use of the Subbotin family of probability densities in a statistical analysis environment. The package contains various programs for the maximum likelihood estimation of an unknown distribution and for
Giulio Bottazzi
core
Advanced Engineering Materials, EarlyView.Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller +6 more
wiley +1 more source