Results 41 to 50 of about 172,921 (302)
Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology
Advanced Engineering Materials, EarlyView.We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham +7 more
wiley +1 more source
Methodology for calculation of static force characteristic of vibration protection mechanism of a seat with a tension roller [PDF]
Научно-технический вестник Брянского государственного университетаThe problem of vibration and shock protection of ground transport and technological machine operators is relevant. Increased productivity increases vibrations that cause diseases and reduce the performance of operators.
Korytov M.S. +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Energy Science & EngineeringAs a key component of the power industry, the rapid growth of the wire and cable industry has exposed it to the challenge of carbon emissions. However, there is still a lack of research on organizations’ carbon footprint in the wire and cable industry ...
Hao Lu +4 more
doaj +1 more source
EnergiesPartial discharge (PD) is a critical indicator of insulation degradation in high-voltage DC systems, necessitating accurate diagnosis to ensure long-term reliability.
Sung-Ho Yoon +5 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Reliability Evaluation of Improved Sampling Method for Mechanical Test of Cable Insulation
EnergiesUnderground and submarine power cables are subjected to mechanical stress during installation and operation, which degrades the cable insulation and reduces the reliability of power transmission.
Seung-Won Lee +5 more
doaj +1 more source
A study on motion analysis and control of mechanical systems connected by a cable
Nihon Kikai Gakkai ronbunshu, 2019 Cables connected to mechanical systems enable efficiently power supply to the system and also enable high speed communication even in a poor communication environment.
Takeshi YAMAMOTO +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.High‐frequency (HF) welding of steel is limited by oxide inclusions that degrade weld quality. This study demonstrates, for the first time, the integration of a nonthermal Ar/H2 dielectric barrier discharge (DBD) plasma jet into HF welding. Local plasma treatment provides effective shielding and in‐situ oxide reduction, resulting in markedly fewer and ...
Viktor Udachin +4 more
wiley +1 more source