Results 31 to 40 of about 35,381 (299)
Nano–Crystalline Mn–Ni–Co–O Thermistor Powder Prepared by Co–Precipitation Method
Powders, 2023 Here, we demonstrate that nano–sized Mn–Ni–Co–O powder can be prepared at a low temperature via a co–precipitation method. In this work, Mn2+ was partially oxidized to Mn3+ ions in an aqueous solution by adding an oxidizing agent (H2O2).
Duc Thang Le, Jeong Ho Cho
doaj +1 more source
Challenges during Flash Lamp Annealing of Aerosol‐Deposited Barium Titanate Films
Advanced Engineering Materials, EarlyView.Aerosol deposition is used to rapidly deposit barium titanate films with thicknesses ranging from 2 to 16 μm at room temperature, eliminating the need for further densification. However, to recover the electromechanical properties, annealing is required, which limits the usage of temperature‐sensitive substrates.
Michel Kuhfuß +7 more
wiley +1 more source
Revista IBRACON de Estruturas e MateriaisEste trabalho descreve a caracterização de cinzas do bagaço de cana-de-açúcar produzidas a partir de queima controlada e moagem ultrafina. Inicialmente, as condições ótimas de queima do bagaço foram determinadas com o objetivo de alcançar a máxima ...
G. C. Cordeiro +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
Effect of Calcination Rate on Performance of Co-precipitated Cu-MgO Catalyst in Hydrogenation of Furfural [PDF]
Journal of Sciences, Islamic Republic of Iran, 2019 Co-precipitated Cu-MgO catalysts were prepared and evaluated for the gas-phase hydrogenation of furfural. The effect of heating rate at the calcination step was studied by comparing the performance of three catalysts prepared via the same procedure but ...
Mohammad Ghashghaee +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Electrified Externally Heated Rotary Calciner for Calcination of Cement Raw Meal
Heliyon, 2023 The cement industry can reduce its CO2 emissions by electrifying the calciner. It can avoid emissions from fuel combustion and produce pure CO2 from the calcination reaction (CaCO3 → CaO + CO2) for direct capture. A differential-algebraic equation (DAE) model of an electrified rotary calciner was developed and validated against experimental results ...
Ron M. Jacob +2 more
openaire +4 more sources
Advanced Functional Materials, EarlyView.This work explores Li‐substituted P2 layered oxides for Na‐ion batteries by crystallographic and electrochemical studies. The effect of lithium on superstructure orderings, on phase transitions during synthesis and electrochemical cycling and on the interplay of O‐ versus TM‐redox is revealed via various advanced techniques, including semi‐simultaneous
Mingfeng Xu +5 more
wiley +1 more source
Revista UIS Ingenierías, 2020 In this investigation work, the valuation of the surface oxide waste from reinforcing steel bars through to its thermal transformation into a pigment composed mainly of hematite (ɑ-Fe2O3) is reported.
María Angélica Colpas-Ruiz +4 more
doaj
Advanced Functional Materials, EarlyView.HKUST‐1/TiO2 composite materials show a very high photocatalytic hydrogen evolution rate which increases as a function of the irradiation time until reaching a plateau and even surpasses the performance of the 1%Pt/TiO2 material after three photocatalytic cycles.
Alisha Khan +9 more
wiley +1 more source