Results 41 to 50 of about 361,755 (287)
Raster linearity of video cameras calibrated with precision tester [PDF]
, 1964 The time between transitions in the video output of a camera is measured when registered at reticle marks on the vidicon faceplate.
core +1 more source
The QUEST Data Processing Software Pipeline [PDF]
, 2007 A program that we call the QUEST Data Processing Software Pipeline has been written to process the large volumes of data produced by the QUEST camera on the Samuel Oschin Schmidt Telescope at the Palomar Observatory. The program carries out both aperture
Anne Bauer +8 more
core +2 more sources
Thermoreflectance Detection of Point Defects Resulting from Focused Ion Beam Milling
Advanced Engineering Materials, EarlyView.Focused ion beam (FIB) milling is a common tool for nanoscale material processing, however irradiation damage, redeposition, and contamination can occur. We use several characterization tools to show FIB‐induced effects beyond 1 mm from the milled area.
Thomas W. Pfeifer +3 more
wiley +1 more source
Calibration Techniques for Accurate Measurements by Underwater Camera Systems
Sensors, 2015 Calibration of a camera system is essential to ensure that image measurements result in accurate estimates of locations and dimensions within the object space.
Mark Shortis
doaj +1 more source
A Novel and Simplified Extrinsic Calibration of 2D Laser Rangefinder and Depth Camera
Machines, 2022 It is too difficult to directly obtain the correspondence features between the two-dimensional (2D) laser-range-finder (LRF) scan point and camera depth point cloud, which leads to a cumbersome calibration process and low calibration accuracy. To address
Wei Zhou +5 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Stereo vision calibration procedure for 3D surface measurements [PDF]
, 2006 In reverse engineering, rapid prototyping or quality control with complex 3D object surfaces, there is often the need to scan a complete 3D model using laser digitizers. Those systems usually use one camera and one laser,- using triangulation techniques;
Fonseca, Jaime C. +2 more
core +1 more source
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
Advanced Engineering Materials, EarlyView.This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
Sensors, 2011 Time-of-flight cameras, based on Photonic Mixer Device (PMD) technology, are capable of measuring distances to objects at high frame rates, however, the measured ranges and the intensity data contain systematic errors that need to be corrected.
Mehran Sattari +3 more
doaj +1 more source
Calibration Method of the Monocular Omnidirectional Stereo Camera [PDF]
, 2021 Ryota Kawamata +4 more
openalex +1 more source