Results 11 to 20 of about 193,763 (276)

Observation of Quantum Capacitance of individual single walled carbon nanotubes [PDF]

open access: yes, 2008
We report a measurement on quantum capacitance of individual semiconducting and small band gap SWNTs. The observed quantum capacitance is remarkably smaller than that originating from density of states and it implies a strong electron correlation in ...
Cui, Xiaodong   +3 more
core   +2 more sources

Measurement of Gas-Liquid Two-Phase Flow in Micro-Pipes by a Capacitance Sensor

open access: yesSensors, 2014
A capacitance measurement system is developed for the measurement of gas-liquid two-phase flow in glass micro-pipes with inner diameters of 3.96, 2.65 and 1.56 mm, respectively. As a typical flow regime in a micro-pipe two-phase flow system, slug flow is
Haifeng Ji   +4 more
doaj   +1 more source

Implementation of a Controller for a Space-Grade, Piezo-Actuated Fabry-Perot Interferometer

open access: yesIEEE Access, 2022
A tunable Fabry-Perot interferometer (FPI) can be used as an optical band-pass filter. This type of filter is used in spectrometers and spectral imagers. The transmitted wavelength depends on the optical cavity adjusted by an electronic controller.
Christer Holmlund, Roberts Trops
doaj   +1 more source

Gate-capacitance extraction from RF C-V measurements [PDF]

open access: yes, 2004
In this work, a full two-port analysis of an RF C-V measurement set-up is given. This two-port analysis gives insight on the limitations of the commonly used gate capacitance extraction, based on the Y/sub 11/ parameter of the device.
Kort, R. de, Sasse, G.T., Schmitz, J.
core   +3 more sources

Parasitic Effects on Electrical Bioimpedance Systems: Critical Review

open access: yesSensors, 2022
Parasitic capacitance represents the main error source in measurement systems based on electrical impedance spectroscopy. The capacitive nature of electrodes’ impedance in tetrapolar configuration can give origin to phase errors when electrodes are ...
David William Cordeiro MarcĂ´ndes   +2 more
doaj   +1 more source

Fast RF-CV characterization through high-speed 1-port S-parameter measurements [PDF]

open access: yes, 2010
We present a novel method to measure the capacitance-voltage relation of an electronic device. The approach is accurate, very fast, and cost-effective compared to the existing off-the-shelf solutions.
Herfst, R.W.   +4 more
core   +3 more sources

Design of capacitance measurement module for determining critical cold temperature of tea leaves

open access: yesSensing and Bio-Sensing Research, 2016
Critical cold temperature is one of the most crucial control factors for crop frost protection. Tea leaf's capacitance has a significant response to cold injury and appears as a peak response to a typical low temperature which is the critical temperature.
Yongzong Lu   +4 more
doaj   +1 more source

Elegant procedure to estimate series capacitance of a uniform transformer winding from its measured FRA: implementable on existing FRA instruments

open access: yesHigh Voltage, 2020
A simple procedure to estimate series capacitance of a uniform transformer winding from its measured frequency response analysis (FRA) and shunt capacitance is presented. Unlike previously published approaches, this method does not involve any cumbersome
Ashiq Muhammed   +3 more
doaj   +1 more source

Completely automated system for capacitance measurement through new accurate capacitance box

open access: yesInternational Journal of Metrology and Quality Engineering, 2017
Capacitance boxes (CBs) are extensively used in electrical laboratories for calibration of capacitance measurement devices. In this paper, a new recently fabricated CB has been presented to be used for automatic calibrations through its 4096 output ...
Raouf M. Helmy A.
doaj   +1 more source

Novel Stable Capacitive Electrocardiogram Measurement System [PDF]

open access: yesSensors, 2021
This study presents a noncontact electrocardiogram (ECG) measurement system to replace conventional ECG electrode pads during ECG measurement. The proposed noncontact electrode design comprises a surface guard ring, the optimal input resistance, a ground guard ring, and an optimal voltage divider feedback. The surface and ground guard rings are used to
Chi-Chun Chen   +2 more
openaire   +3 more sources

Home - About - Disclaimer - Privacy