Results 21 to 30 of about 26,738 (304)

Analysis of The Effect of Bank Capacitor Placement as Voltage Drop Increase in Distribution Network

open access: yesAndalasian International Journal of Applied Science, Engineering, and Technology, 2022
The quality of electricity distribution in the distribution network is an important thing that must be considered. To maintain the quality of electrical energy, there are several parameters that must be considered in the distribution network, including ...
Muhammad Yudha Rofandy   +2 more
doaj   +1 more source

Study of Capacitor Bank Switching Transient in Distribution Network

open access: yesMATEC Web of Conferences, 2018
The power factor improvement has a great concern in the distribution system due to large motor installed in industrial system. The capacitor bank was installed to improve the power factor in the distribution system.
Nisja Indra, Zoni Mirza, Arnita
doaj   +1 more source

Reactive Power Impacts on LCL Filter Capacitor Lifetime in Grid-Connected Inverter

open access: yesIEEE Open Journal of Power Electronics, 2020
With the increasing penetration of renewable power, its reliability and cost-effective production are becoming more important. A filter is inserted between the grid-connected inverter and the power grid to reduce the PWM switching harmonics, which may ...
Dao Zhou, Huai Wang, Frede Blaabjerg
doaj   +1 more source

Performance up gradation of static VAR compensator with thyristor binary switched capacitor and reactor using model reference adaptive controller

open access: yesAutomatika, 2022
There are various static var compensator configurations are available and listed in the literature. Their performances are evaluated based on their voltage support, dynamic response, losses, cost, and additional filter requirement, if any. In this paper,
Swapnil D. Patil   +3 more
doaj   +1 more source

Mitigation of Power Losses and Enhancement in Voltage Profile by Optimal Placement of Capacitor Banks With Particle Swarm Optimization in Radial Distribution Networks

open access: yesAdvances in Electrical and Electronic Engineering, 2022
The prime purpose of placing a capacitor bank in a power system is to provide reactive power, reduce power losses, and enhances voltage profile. The main challenge is to determine the optimum capacitor position and size that reduces both system power ...
Muhammad Fawad Shaikh   +5 more
doaj   +1 more source

The Effect of Power factor Improvement on Switching Transients: A Case of FUMMAN Agricultural Products Industry Plc. [PDF]

open access: yes, 2015
Industrial loads are mostly inductive and hence operate at low power factor. Several methods including the installation of capacitor banks are available for improving power factor in order to reduce the kilovolt ampere (kVA) demand of the load and power ...
Adejumobi, I. A.   +3 more
core   +1 more source

System-based testing of a voltage differential protection scheme for shunt capacitor bank

open access: yesEnergy Reports, 2020
Capacitor banks used in substations cause a maintenance problem, which consume time for technicians to identify the root cause of the problem which can result in voltage control issues.
Senthil Krishnamurthy   +2 more
doaj   +1 more source

Perencanaan dan analisis kelayakan investasi proyek pemasangan kapasitor bank pada instalasi pemanfaatan energi listrik

open access: yesJurnal Eltek, 2020
Data pemakaian daya dan tagihan listrik pada stasiun pompa air Sumber Wendit 3 pada bulan Juli 2018 sampai Januari 2019, diketahui bahwa faktor daya rata-rata adalah 0,82, yaitu dibawah standar PT.
Epiwardi epiwardi   +2 more
doaj   +1 more source

Design of a 3 GHz fine resolution LC DCO [PDF]

open access: yes, 2017
In this thesis, the design of a fine resolution LC digitally controlled oscillator (DCO) is introduced. Two NMOS varactor banks are used to achieve 12 bits medium and fine frequency tuning.
Zhao, Xuming, active 21st century
core   +1 more source

Solidification of Al alloys under electromagnetic pulses and characterization of the 3D microstructures under synchrotron x-ray tomography [PDF]

open access: yes, 2015
A novel programmable electromagnetic pulse device was developed and used to study the solidification of Al-15 pct Cu and Al-35 pct Cu alloys. The pulsed magnetic fluxes and Lorentz forces generated inside the solidifying melts were simulated using finite
Andrew J. Bodey   +42 more
core   +1 more source

Home - About - Disclaimer - Privacy