Results 151 to 160 of about 171,996 (199)
Some of the next articles are maybe not open access.

Synergistic Mechanisms of Steelmaking Slag Coupled With Carbide Slag for CO2 Mineralization

International Journal of Greenhouse Gas Control, 2021
Abstract Mineralization is an important means for emission reduction and utilization of CO2. Industrial calcium-based by-products such as steelmaking slag and carbide slag are often used as inexpensive mineralizers for CO2. In this investigation, the pH was tested on-line during the mineralization process of CO2 and steelmaking slag, carbide slag and
Hongqiang Liao, Fangqin Cheng
exaly   +2 more sources

Desulphurization mechanism and engineering practice of carbide slag

Environmental Science and Pollution Research, 2022
In order to give full play to the alkaline neutralization value of carbide slag and reduce the environmental hazards of carbide slag, it is of great practical significance to study the resource utilization of carbide slag. The adsorption of sulfur compounds on carbide slag was studied in the laboratory, and the process parameters of carbide slag ...
Jiamin, Qi   +4 more
openaire   +2 more sources

Synergistic solidification/stabilization of electrolytic manganese residue and carbide slag

Science of The Total Environment, 2022
Electrolytic manganese residue (EMR) contains high concentrations of NH4+ and heavy metals, such as Mn2+, Zn2+, Cu2+, Pb2+, Ni2+ and Co2+, while carbide slag (CS) contains high amount of OH- and CO32-, both posing a serious threat to the ecosystem. In this study, EMR and CS synergistic stabilization/solidification (S/S) was discussed science CS could ...
Dejun, He   +6 more
openaire   +2 more sources

Preparation of Xonotlite Whiskers from Carbide Slag

Key Engineering Materials, 2010
Carbide slag was used as raw materials for the first time to prepare xonontlite whiskers via a hydrothermal route without special instruments and synthesis conditions. And the effect of pH value of emulsion of carbide slag and hydrothermal conditions on removal rate of impurities, morphology and crystallinity of synthesized xonotlite whiskers were ...
Fei Liu   +4 more
openaire   +1 more source

Comprehensive Utilization of Carbide Slag

2019
Carbide slag (acetylene sludge) is the industrial residue, which is discharged when the hydrolysis of calcium carbide is undertaken to prepare acetylene. The slag mainly consists of Ca(OH)2. If the carbide slag is stacked on the spot, it may pollute water resources near the stacking field.
Fenglan Han, Laner Wu
openaire   +1 more source

Influence of Carbon on the Strength of Adhesion of Iron to White Slags and Carbide Slags

1965
In tapping special steels from electric arc furnaces, the metal becomes appreciably higher in oxide inclusions, due to the absorption of droplets of furnace slag [1–3]. The tendency of this slag to become entrapped increases with increase in the calcium carbide content of the slag [4–5].
S. I. Popel’, N. K. Dzhemilev
openaire   +1 more source

Thermal analysis of carbide slag solutions

Journal of Thermal Analysis, 1995
A model of slag refining processes and a method of determining the reduction capability of slag solutions are presented. Carbide slags were analysed by DTA methods.
openaire   +1 more source

Carbide slag–activated ground granulated blastfurnace slag for soft clay stabilization

Canadian Geotechnical Journal, 2015
This study addresses the use of an industry by-product, carbide slag (CS), to activate another industry by-product, ground granulated blastfurnace slag (GGBS), for soft clay stabilization in comparison to Portland cement (PC). The properties of CS–GGBS stabilized clays were investigated through unconfined compressive strength (UCS) test, mercury ...
Yaolin Yi   +3 more
openaire   +1 more source

Application of Carbide Slag in Autoclaved Aerated Concrete

2018
Carbide slag is a solid waste which is difficult to handle. When it is used to substitute for lime to produce autoclaved aerated concrete (AAC) block without necessary treatments, the aeration efficiency is low and density of the AAC block is high. Besides, the initial mechanical strength of the block is lower because of lower curing temperature in ...
Han Fuqiang, Tan Xing, Zhao Fengqing
openaire   +1 more source

CO2 capture performance of cement-modified carbide slag

Korean Journal of Chemical Engineering, 2016
A novel and low-cost synthetic CO2 sorbent for calcium looping process, cement-modified carbide slag (CMCS), was synthesized from carbide slag, aluminate cement and by-product of biodiesel by combustion. The effects of synthesis conditions such as combustion temperature, combustion duration, hydration, by-product of biodiesel and cement addition and ...
Xiaotong Ma   +4 more
openaire   +1 more source

Home - About - Disclaimer - Privacy