Results 131 to 140 of about 2,387,895 (357)
Advanced Engineering Materials, EarlyView.The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann +6 more
wiley +1 more source
Graphite-reinforced aluminum composite [PDF]
, 1971 Metallic composite prepared for utilization which remains intact without aluminum/carbon reactions, is less expensive than other structural materials, and yields a flexible composite ...
Lalacona, F. P.
core +1 more source
Design and preparation of carbon fiber, carbon particle doped C4H10O4 phase change thermal storage materials and performance [PDF]
, 2023 Bingnan Chen, Jun Liu
openalex +1 more source
Effect of Laser Deoxidation on Adhesive‐Bonded Aluminum in an Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.This study investigates laser ablation of aluminum under oxygen‐free conditions. The goal is to produce oxide‐free substrates that enable improved adhesive bonding with epoxy. Optimized laser parameters (90% overlap, 300 µJ) combined with oxide‐free substrates result in the highest tensile strength of the adhesive bond.
Sandra Gerland +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
eScienceTo gain a deep understanding and address key issues in perovskite photovoltaics, such as power conversion efficiency (PCE) and long-term stability, defect passivation and analysis of the device performance are required.
Jing Chen +7 more
doaj +1 more source
Lignin‐Derived Advanced Carbon Materials
, 2015 Sabornie Chatterjee, Tomonori Saito
openalex +2 more sources
Sol–Gel Derived Polymer Precursors for Stereolithography of ZrC
Advanced Engineering Materials, EarlyView.ZrC is a critical material target for extreme temperature conditions. This report describes a protocol for preparing ZrC ceramics via stereolithography and examines the impact of the polymer matrix on carbothermal reduction and mechanical stability of 3D printed ZrC.
Charles J. Rafalko +2 more
wiley +1 more source
Electrochemical and electrical properties of nickel molybdate / carbon material composites
, 2021 Olha Popovych +4 more
openalex +2 more sources