Results 211 to 220 of about 6,470 (263)
Some of the next articles are maybe not open access.
Advances in X-ray Analysis, 1992
SummaryA set of standard samples consisting of low alloy steels, tool steels and a graphite standard was prepared carefully for measurements by polishing (down to 0.3μm alumina powder) and cleaning of the surfaces. Photographs from optical and scanning electron microscopical images were taken in order to provide information about the microstructure ...
F. Weber, M. Mantler, L. Wariwoda
openaire +1 more source
SummaryA set of standard samples consisting of low alloy steels, tool steels and a graphite standard was prepared carefully for measurements by polishing (down to 0.3μm alumina powder) and cleaning of the surfaces. Photographs from optical and scanning electron microscopical images were taken in order to provide information about the microstructure ...
F. Weber, M. Mantler, L. Wariwoda
openaire +1 more source
Microforming of a low carbon steel.
2009In recent years the use of micro products has been strongly increased. Microforming can be considered the most suitable technology to manufacture very small metallic parts for mass production. Performances are strongly coupled with material properties, determining forming forces, interface pressures and tooling life. However research activities on this
Berti G., Monti M., D'ANGELO, Luciano
openaire +2 more sources
2017
<div class="section abstract"> <div class="htmlview paragraph">This document describes the processing and fabrication of carbon and alloy steels. The basic steelmaking process including iron ore reduction, the uses of fluxes, and the various melting furnaces are briefly described.
+4 more sources
<div class="section abstract"> <div class="htmlview paragraph">This document describes the processing and fabrication of carbon and alloy steels. The basic steelmaking process including iron ore reduction, the uses of fluxes, and the various melting furnaces are briefly described.
+4 more sources
Fusion of Low Carbon Steel Scrap in the Middle Carbon Steel Melt
Kovine zlitine tehnologije, 1996A quasi three-dimensional mathematical model of fusion of cylindrical steel scrap in converter melt was developed. The model was solved using the implicit altermating direction method. The obtained algorithm was programmed in ASCII FORTRAN for the computer SPERRY 1100/72.
openaire +1 more source
1956
The data show a wide range in relaxation strengths. Study of the data shows that the following factors are involved: 1. The major cause for the wide range in relaxation strengths at 850 F appears to be molybdenum content, as is shown by the figures on page 20.
openaire +1 more source
The data show a wide range in relaxation strengths. Study of the data shows that the following factors are involved: 1. The major cause for the wide range in relaxation strengths at 850 F appears to be molybdenum content, as is shown by the figures on page 20.
openaire +1 more source
2017
<div class="section abstract"> <div class="htmlview paragraph">This specification covers low-carbon steel in the form of bars, forgings, mechanical tubing, sheet, strip, plate, and forging stock.</div></div>
openaire +2 more sources
<div class="section abstract"> <div class="htmlview paragraph">This specification covers low-carbon steel in the form of bars, forgings, mechanical tubing, sheet, strip, plate, and forging stock.</div></div>
openaire +2 more sources