Results 11 to 20 of about 442,192 (347)
Colour Metallography of Cast Iron [PDF]
China Foundry, 2009 Cast iron, as a traditional metal material, has advantages of low total cost, good castability and machinability, good wear resistance and low notch sensitivity, and is still facing tough challenge in quality, property and variety of types etc.
Zhou Jiyang
doaj +2 more sources
Experimental and Numerical Analysis of Thermal Fatigue of Grey Cast Iron Ingot Mould. [PDF]
Materials (Basel)Mirek P, Piekło J, Garbacz-Klempka A.
europepmc +2 more sources
Damage ratio strength criterion for cast iron
Journal of Materials Research and Technology, 2022 According to the assumption of small strains and total strain decomposition of cast iron, the expressions of the inelastic principal strain rate and relative energy dissipation rate of cast iron are derived, and the parameters of the tensile and ...
Faxing Ding +4 more
doaj +1 more source
Spheroidal Cast Iron for Works at Low Temperature – Requirements, Structure, Properties, Control of the Production Process [PDF]
Archives of Metallurgy and Materials, 2022 Two standardised grades of spheroidal cast iron determined in standard EN PN 1563 – 1997 as: EN-GJS-350 – 22LT (T = –40°C) and EN GJS 400 – 18LT (T = –20°C) are intended for work at low temperatures: –20 and –40oC.
J. Zych +4 more
doaj +1 more source
Microsegregation in Nodular Cast Iron with Carbides [PDF]
, 2012 In this paper results of microsegregation in the newly developed nodular cast iron with carbides are presented. To investigate the pearlitic and bainitic cast iron with carbides obtained by Inmold method were chosen.
G. Gumienny, S. Pietrowski
core +4 more sources
The influence of copper on the properties of ductile iron for producing centrifugally cast rolls [PDF]
, 2018 An intentional change in material properties is an important condition for castings production. It is one way how to meet the casting requirements of how to adapt the material properties to the operating conditions.
Hampl, Jiří +2 more
core +1 more source
Archives of Foundry Engineering, 2016 The paper presents the microstructure and selected properties of ausferritic nodular cast iron annealed at the temperature 520 and 550°C. This choice was dictated by the temperatures used in the practice of nitriding.
Gumienny G., Klimek L., Kurowska B.
doaj +1 more source
Selective Laser Sintering and Post Processing of Fully Ferrous Components [PDF]
, 2008 Commercially available steel for indirect SLS (LaserFormtm A6 tool steel) is normally post-process infiltrated with a copper-based material. While such parts have high thermal conductivity necessary for short- and medium-run injection molding dies ...
Bourell, David L. +1 more
core +1 more source
The Effect of Aluminium on Graphitization of Cast Iron Treated with Cerium Mixture
Archives of Foundry Engineering, 2014 The work determined the influence of aluminium in the amount from about 0.6% to about 8% on graphitization of cast iron with relatively high silicon content (3.4%-3.9%) and low manganese content (about 0.1%).
Soiński M. S. +3 more
doaj +1 more source
Hybrid Advances, 2023 This paper aims to examine the microstructure, corrosion resistance and hardness of bone particles reinforced cast iron for advanced applications in marine and automotive industries, especially for the fabrication of engine blocks.
Itopa Godwin Akande +2 more
doaj +1 more source