Results 231 to 240 of about 1,862 (264)

Effect of water mist on cooling process of casting die and microstructure of AlSi11 alloy

, 2010
R. Władysiak
openalex   +1 more source

A Review on Traditional Processes and Laser Powder Bed Fusion of Aluminum Alloy Microstructures, Mechanical Properties, Costs, and Applications. [PDF]

Materials (Basel)
Wang X, Zhang D, Li A, Yi D, Li T.
europepmc   +1 more source

INFLUENCE OF THE COOLING RATE DURING QUENCHING ON THE TOUGHNESS AT TYPICAL WORKING TEMPERATURES OF DIE-CASTING DIES

, 2009
Henrik Jesperson
openalex   +1 more source

Investigation of the Microstructure and Mechanical Properties of Heat-Treatment-Free Die-Casting Aluminum Alloys Through the Control of Laser Oscillation Amplitude. [PDF]

Materials (Basel)
Xu H, Shao J, Han L, Wang R, Jiang Z, Miao G, Zhang Z, Cheng X, Bai M.   +8 more
europepmc   +1 more source

Development and Characterization of AZ91 Magnesium Alloy Reinforced with Ti Wires. [PDF]

Materials (Basel)
Wyrwa W, Filipiak-Kaczmarek A, Nikodem A.   +2 more
europepmc   +1 more source

Robocasting as an Additive Manufacturing Method for Oxide Ceramics: A Study of Mechanical Properties and Microstructure. [PDF]

Materials (Basel)
Przybyła S, Kwiatkowski M, Kwiatkowski M, Hebda M.   +3 more
europepmc   +1 more source

Evaluation of a heat flux sensor for spray cooling for the die casting processes

Journal of Materials Processing Technology, 2006
During the die casting process, lubricants are sprayed in order to cool the dies and facilitate the ejection of the casting. In this paper, a new technique for measuring the heat flux during lubricant application is evaluated. Data from experiments conducted using water spray are first presented.
Adrian S. Sabau, Zhuoxi Wu
openalex   +2 more sources

Some of the next articles are maybe not open access.

Related searches:

Cooling-Assisted Ultrasonic Grain Refining of Aluminum E380 Die Casting Alloy

International Journal of Metalcasting, 2021
Die cast alloys have to be poured at temperatures much higher than their liquidus in order to make the alloys castable. Pouring at a high temperature reduces the formation of dendrites in the shot sleeve which tend to choke the flow at the in-gate but causes increased damage to the shot tooling and dies. Forming globular grains in the shot sleeve is an
C. Vian, C. Kibbey, Y. Chen, C. Kuntz, Q. Han   +4 more
openaire   +1 more source

Additively Manufactured High-Performance Conformally Cooled H13 Tool Steel Die Insert for Pressure Die Casting

Transactions of the Indian National Academy of Engineering, 2021
The performance and life of pressure die casting tools and inserts can be improved by providing efficient conformal cooling. These tools are usually made of H13 tool steel, and additive manufacturing offers the freedom to the design and process to incorporate cooling channels.
D. M. Santhoshsarang, K. Divya, Gururaj Telasang, S. Soundarapandian, Ravi Bathe, G. Padmanabham   +5 more
openaire   +1 more source