Results 41 to 50 of about 134,644 (168)

Measurement of relative velocity distribution in centrifugal blower impeller.

TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B, 1985
The relative flow patterns of a centrifugal blower impeller were visualized on the planes of hub, intermediate and shroud by the spark tracing method simultaneously visualizing stream lines, that indicates the flow direction. The stationary image of flow patterns in the impeller was observed using the rotating image stopping processor in which a ...
NAKAYAMA, Yasuki, YAMAMOTO, Toru, AOKI, Katsumi, OHTA, Hiroaki   +3 more
openaire   +3 more sources

Mechanical Vapor Recompression in Distillation: A Framework to Analyze Technical Feasibility, Economic Competitiveness, and Ecological Benefits

Chemie Ingenieur Technik, Volume 98, Issue 7, Page 342-354, July 2026.
Communication: An approach for a holistic evaluation of distillation processes with mechanical vapor recompression combining an initial energy potential analysis, shortcut methods for the compressor and reboiler design, and the determination of economic and ecological performance parameters is presented.
Katharina Jasch, Franziska Lais, Hannes Schneider, Mandy Paschetag, Stephan Scholl   +4 more
wiley   +1 more source

Optimization of Energy Consumption in Intermittent Drying of Clay Using a Central Composite Design

Energy Technology, Volume 14, Issue 7, July 2026.
This study investigates the influence of drying temperature, air velocity, and intermittence ratio on the drying performance and energy consumption of a convective intermittent drying process. Multi‐response optimization identifies optimal operating conditions that significantly reduce drying time and supplied power while enhancing the drying ...
Nour El Houda Ben Mustapha, Houda Hachem, Daoued Mihoubi   +2 more
wiley   +1 more source

Environmentally Friendly R2R Process for Flexible Perovskite Solar Cells via DMF‐Free Cosolvent Ink

EcoMat, Volume 8, Issue 7, July 2026.
A DMF‐free two‐step slot‐die coating process for roll‐to‐roll fabrication of perovskite solar cells is demonstrated using a DMSO:ACN cosolvent system. The process enables controlled porous PbI2 formation and efficient FAI conversion, resulting in high‐quality perovskite films with 15.84% efficiency on flexible substrates and offering a scalable ...
Geon Yeong Park, Hyeji Han, Min‐Jae Kim, Nara Han, Yong Cheon Park, Min Kim, Jongchul Lim, Dong Seok Ham   +7 more
wiley   +1 more source

Heat Shielding of Steel With a Polyelectrolyte Coacervate Coating

Macromolecular Materials and Engineering, Volume 311, Issue 7, July 2026.
A polyelectrolyte complex coacervate is reinforced with two types of nanoclay to create a heat shielding layer for steel that is low‐cost and efficient, yet applicable to a variety of civil infrastructure to aircraft components. The incorporation of clay into the coacervate aids in the formation of a reinforced char barrier during degradation ...
Justin D. Alpern, Anastasia B. Contreras, Sarah G. Fisher, Margaret J. Karim, Jaime C. Grunlan   +4 more
wiley   +1 more source

The characteristic of a centrifugal blower and the flow near the Tongue

Journal of the Visualization Society of Japan, 2000
A study of internal centrifugal blower is very interest in case problems for improve the characteristics. Also, the form of volute tongue which have an affects to characteristics centrifugal blower. This paper is described about effect of tongue shape for characteristics of centrifugal blower.
KOIZUMI, Atsushi, ODAGIRI, Tetsuo, AOKI, Katsumi   +2 more
openaire   +2 more sources

Simulation of Impeller Exit Flows of A Centrifugal Blower

International Journal of Recent Technology and Engineering (IJRTE), 2019
The flow through centrifugal impeller is highly non uniform due to formation of regions with different energy level. These region mixes at the exit of the impeller leading to loss and bringing down the efficiency of the centrifugal impeller. The present study focus on analyzing the flow through an impeller and investigating the impeller exit flows. The
Seralathan S*, Balaji R, Mukesh Nadarajan, Ijas Ahamed A, Hariram V   +4 more
openaire   +1 more source

A Portable Servoregulation Controller to Automate CO₂ Removal in Artificial Lungs. [PDF]

Bioengineering (Basel), 2022
Shaikh N, Zhang A, Jenter J, Nikpreljevic B, Toomasian J, Lynch W, Rojas-Peña A, Bartlett RH, Potkay JA.   +8 more
europepmc   +1 more source

Effect of vaned and vaneless diffuser on the performance of turbo blowers

Engineering review
The design of the diffuser significantly impacts the efficiency and overall performance of turbo blowers. The choice of diffuser type in centrifugal compressors and turbo blowers impacts efficiency.
P. Demircioglu, I. Bogrekci, Berkay Sert, Mujtaba Abbakar, Ahmet Gogebakan   +4 more
semanticscholar   +1 more source

Assessment of the Propulsion System Operation of the Ships Equipped with the Air Lubrication System. [PDF]

Sensors (Basel), 2021
Giernalczyk M, Kaminski P.
europepmc   +1 more source