Results 31 to 40 of about 473,413 (369)
Fabrication of ceramic micro-scale hollow components by micro-powder injection moulding [PDF]
, 2012 Rapid developments in microsystem technologies demand ceramic microcomponents of increasing geometrical complexity. State-of-the-art microfabrication routes of ceramics are either limited in geometrical complexity and/or high volume capabilities. This
Alcock, Jeffrey R., Attia, Usama M.
core +1 more source
Journal of Advanced Ceramics, 2017 Silicon carbide (SiC) fiber has recently received considerable attention as promising next-generation fiber because of its high strength at temperatures greater than 1300 °C in air.
Tae-Eon Kim +2 more
doaj +1 more source
Tm-Yb Doped Optical Fiber Performance with Variation of Host-Glass Composition
Advances in Electrical and Electronic Engineering, 2014 The fabrication process of Thulium-Ytterbium doped optical fiber comprising different host glass through the Modified Chemical Vapor Deposition (MCVD) coupled with solution doping technique is presented.
Anirban Dhar +3 more
doaj +1 more source
Mathematical Modeling for Ceramic Shape 3D Image Based on Deep Learning Algorithm
Advances in Mathematical Physics, 2021 Ceramic image shape 3D image modeling focuses on of ceramic that was obtained from the camera imaging equipment such as 2D images, by normalization, gray, filtering denoising, wavelet image sharpening edge enhancement, binarization, and shape contour ...
Lijian Zhang, Guangfu Liu
doaj +1 more source
Ophthalmology, 1980 This paper describes a new type of corneal prosthesis made of aluminum oxide ceramic. The implant consists of a retaining plate with a 3-mm central performation to which an optical cylinder is threaded. The cylinder also made of ceramic material, has a high refractive index and 60 diopters of power. Experimental study has shown that soft tissue adheres
From the Department of Ophthalmology, University of Florida, College of Medicine, J. Hillis Miller Health Center, Gainesville ( host institution ) +2 more
openaire +4 more sources
Journal of Asian Ceramic Societies, 2016 Clay–alumina compositions of 0, 20, 40 and 55 weight percent (wt%) clay and rest alumina were maintained in porous support preparation by extrusion followed by sintering at 1300 °C for 2.5 h to obtain 3 mm/2 mm (outer diameter/inner diameter) capillary ...
Rakhi Das +3 more
doaj +1 more source
CrystalsThis study investigates the identification of artificial irradiation in thermoluminescence (TL) pre-dose dating of ancient Chinese porcelain to address the challenges posed by sophisticated counterfeiting techniques. While TL pre-dose dating is effective
Jinwei Li +7 more
doaj +1 more source
Database archive: Cencelle Ceramic analysis
, 2023 Petrographic analysis of Cencelle medieval Ceramic ...
Vollono Giulia +2 more
core +1 more source
CrystalsThe excavation of the Lieshan Kiln site represents a significant advance in the field of ceramic archaeology. Previous scholars fixated on the white porcelain unearthed from this kiln, yet this study zeroed in on celadon from the Northern Song and Jin ...
Qijiang Li +5 more
doaj +1 more source