Results 31 to 40 of about 4,103 (154)
Fullerene particles were incorporated with CF‐reinforced acrylonitrile–butadiene–styrene terpolymer (ABS) matrix at three different compositions by a melt‐compounding process. These insights are crucial for the optimization of conductive hybrid composites for various applications.
Alinda Öyku Akar +4 more
wiley +1 more source
In Situ Curing‐Enabled 3D Printing of Continuous Fiber‐Reinforced Thermosetting Composites
In situ curing‐enabled the 3D printing of continuous fiber/thermoset composites, which were reviewed. Particularly, four types of in situ curing, were discussed, including Radiation‐induced curing, photothermal curing, electrothermal curing, and frontal polymerization. AI‐integrated printing was also analyzed.
Xiaofei Wu +2 more
wiley +1 more source
The article explores how high‐strength steels and press hardening revolutionize lightweight chassis design for heavy‐duty vehicles. It reveals that press hardened steels combined with shot peening can cut weight by up to 34% and reduce environmental impact by 21%–32%.
Violeta Vargas‐Parra +7 more
wiley +1 more source
Rotation capacity of continuous reinforced concrete slab strips revisited
Abstract Rotation capacity is a key characteristic of statically indeterminate reinforced concrete structures, as it (i) enables bending moment redistributions, whether intentionally introduced through optimized reinforcement layouts or arising from unforeseen self‐equilibrated stress states, and (ii) promotes large rotations at failure load, thereby ...
Nathalie Reckinger +2 more
wiley +1 more source
Abstract In this study, the structural behavior of small square steel tube‐reinforced self‐compacting concrete (SSTR‐SCC) columns is investigated under symmetric and asymmetric biaxial eccentric loads. Twelve specimens were cast and tested under biaxial eccentric loads.
Muhammad Naveed +2 more
wiley +1 more source
Abstract This study explores the potential of high‐volume amorphous silica (SiO2) replacement for ordinary Portland cement (OPC) in concrete to reduce carbon emissions. Amorphous SiO2, such as silica fume (SF) and CO2 mineralization‐produced Si‐rich gel, offers superior properties to concrete but is under‐researched for its use in concrete with high ...
Xinlin Ji, Lijie Chen, R. K. L. Su
wiley +1 more source
This study evaluates the tensile performance of single-lap joints with three configurations: CFRP-to-CFRP, Al-to-Al, and CFRP-to-Al. The effect of CFRP and aluminum adherends on joint strength was analyzed based on surface characteristics and mechanical properties.
Abdurohman, Kosim +9 more
openaire +3 more sources
Abstract Accurate estimation of the damping ratio is critical for evaluating floor response spectra and equipment seismic demands in nuclear power plant structures. This study investigates the elastic damping ratio of reinforced concrete walls under limited damage states through shaking table tests and data‐driven modeling.
Hyeon‐Keun Yang, Min‐Kyu Kim
wiley +1 more source
Interfacial properties in the CFRP and CFRP-Ti composites under hygrothermal conditions [PDF]
DOCTOR OF PHILOSOPHY (MAE)
openaire +2 more sources
Abstract Slab–column connections are vulnerable to punching shear, particularly when flexural cracking reduces the effective depth. This study proposes a sustainable dual‐strengthening system to enhance punching resistance and combined flexural–punching performance.
Ahmed Hamoda +3 more
wiley +1 more source

