ELECTRONIC DESIGN OF CHARGE SENSITIVE AMPLIFIERS
Possible ways of electronic design of charge sensitive amplifiers are presented in the paper. Designed amplifiers with semiconductor sensors determine low limit of energy sensitivity at studying of ionized radiation.
A. G. Shvets, И. М. Раренко
openalex +4 more sources
Resistor-less charge sensitive amplifier for semiconductor detectors
Abstract A new concept of a Charge Sensitive Amplifier without a high-value resistor in the feedback loop is presented. Basic spectroscopic parameters of the amplifier coupled to a coaxial High Purity Germanium detector (HPGe) are discussed. The amplifier signal input is realized with an n-channel J-FET transistor.
K. Pelczar, K. Panas, G. Zuzel
openalex +3 more sources
The authors consider design and circuit design techniques of reduction of the influence of the pyroelectric effect on operation of the charge sensitive amplifiers. The presented experimental results confirm the validity of the measures taken to reduce the impact of pyroelectric currents.
V. I. Startsev, Yuvan Sankar Raja S
openalex +2 more sources
Note: A charge sensitive spectroscopy amplifier for position sensitive micro-channel plate detectors
A compact and low noise charge sensitive spectroscopy amplifier which can be integrated into position sensitive micro-channel plate (MCP) detectors has been constructed. The amplifier was optimized by using a wave form generator and tested by a chevron shape MCP detector.
Wei Wang +4 more
openalex +4 more sources
Novel Charge Sensitive Amplifier Design Methodology suitable for Large Detector Capacitance Applications [PDF]
Current mode charge sensitive amplifier (CSA) topology and related methodology for use as pre-amplification block in radiation detection read out front end IC systems is proposed1. It is based on the use of a suitably configured current conveyor topology
Gerard Sarrabayrouse b,c and +3 more
core +3 more sources
Design of a charge-sensitive amplifier for MEMS piezoelectric hydrophone [PDF]
Abstract Hydrophone is an important part of sonar system and convert acoustic signal into electrical signal. However, the electrical signal generated by the hydrophone is relatively weak and cannot be directly used for underwater detection and communication. Therefore, it is necessary to preprocess the generated electrical signal.
Zheng Huang +4 more
openalex +2 more sources
A 0.35μm Low-Noise Stable Charge Sensitive Amplifier for Silicon Detectors Applications
The Charge Sensitive Amplifier (CSA) is the key module of the front-end electronics of various types of Silicon detectors and most radiation detection systems. High gain, stability, and low input noise are the major concerns of a typical CSA circuit in order to achieve amplified susceptible input charge (current) for further processing.
Folla Kamdem Jérôme
openalex +5 more sources
Integrated Circuit Design for Radiation-Hardened Charge-Sensitive Amplifier Survived up to 2 Mrad. [PDF]
Lee C, Cho G, Unruh T, Hur S, Kwon I.
europepmc +3 more sources
Design of a charge sensitive spectroscopy amplifier for Compton camera [PDF]
A charge sensitive spectroscopy amplifier has been designed to couple with the silicon strip detector of a Compton camera. The amplifier was optimized by using a wave form generator and the output gain of 1012V/C was achieved when the shaping time is 1μs.
Wei Wang +4 more
openalex +2 more sources
A Highly Sensitive Light-Induced Thermoelastic Spectroscopy Sensor Using a Charge Amplifier to Improve the Signal-to-Noise Ratio. [PDF]
Ma H, Qiao S, He Y, Ma Y.
europepmc +3 more sources

