Results 61 to 70 of about 38,697 (300)
Advanced Engineering Materials, EarlyView.A numerical–experimental framework is developed for characterizing multi‐matrix fiber‐reinforced polymers (MM‐FRPs) combining epoxy and polyurethane matrices. Harmonic bending tests are integrated with finite element model updating (FEMU) to simultaneously identify elastic and viscoelastic material parameters.
Rodrigo M. Dartora +4 more
wiley +1 more source
Charging-Load Modeling and Optimal Charging-Pile Planning in Highway Service Areas Under the Influence of Holiday Factors [PDF]
Dianli jianshe[Objective] To achieve carbon-peaking and -neutrality goals， the number of electric vehicles （EVs） in China has grown rapidly. However， the growth of EV-charging infrastructure has lagged behind the rapid increase in demand.
LI Zhenkun, XIAO Tianyu, SONG Zhiru, ZHANG Zhiquan
doaj +1 more source
Advanced Engineering Materials, EarlyView.ZnS‐MXene‐TiO2 nanocomposite heterojunction for photocatalytic decomposition of this methylene blue dye (MB) greatly improves light absorption, charge separation, and active site area. Two‐dimensional MXene forms nanocomposites by easily combining them with 0D (quantum dots), 1D (tube and wire), 2D (plane and sheet), and 3D (particle and lamellar ...
Latiful Kabir +7 more
wiley +1 more source
Performances of Anode-resistive Micromegas for HL-LHC
, 2012 Micromegas technology is a promising candidate to replace Atlas forward muon chambers -tracking and trigger- for future HL-LHC upgrade of the experiment.
Alexopoulos, T. +16 more
core +1 more source
Advanced Engineering Materials, EarlyView.Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin +5 more
wiley +1 more source
A Tracking Fiber Detector based on Silicon Photomultipliers for the Kaos Spectrometer
, 2011 A tracking detector based on two meters long scintillating fibers read out by silicon photomultipliers (SiPM) is being developed for the Kaos spectrometer at the Mainz Microtron MAMI. Results from a prototype setup using 2 mm square fibers and large area
Achenbach, P. +2 more
core +1 more source
Characteristics of an x-ray preionized TEA CO laser [PDF]
, 1987 A cryogenically cooled sealed-off x-ray preionized self-sustained discharge CO laser was succesfully operated. It was found that 20 to 40% higher output energies could be obtained using x-ray instead of uv preionization.
Ernst, G.J., Zuidema, R.J.
core +3 more sources
Advanced Engineering Materials, EarlyView.This paper presents a novel approach to reducing oxide layers on metal powders using low‐temperature hydrogen dielectric barrier discharge plasmas at atmospheric pressure. Unlike conventional hydrogen‐plasma reductions, the powders do not contact the plasma directly.
Shukang Zhang +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study reports lightweight polyetherimide triply periodic minimal surfaces lattices coated with carbon nanotube‐reinforced epoxy that combine mechanical robustness with self‐sensing. The conformal coating enhances stiffness, strength and energy absorption while enabling reliable strain monitoring.
A. Triay +3 more
wiley +1 more source
Orderly charging strategy for electric vehicles based on multi-level adjustability
International Journal of Renewable Energy DevelopmentThe development of electric vehicles (EVs) is one of the essential ways to reduce environmental pollution. With the rapid growth in EVs, an orderly charging strategy based on multi-level adjustable charging power is proposed to address the problem of ...
Changlong Teng +4 more
doaj +1 more source