Results 141 to 150 of about 1,184,807 (285)
Announcement: New location of main office of The Journal of Chemical Physics [PDF]
, 2008 Mark M. Cassar
openalex +1 more source
Advanced Engineering Materials, EarlyView.This study presents a 3D representative volume element‐based simulation approach to predict mesoscopic residual stress and strain fields in silicon solid solution‐strengthened ductile cast iron. By modeling phase transformation kinetics with an enhanced Johnson–Mehl–Avrami–Kolmogorov model, the effects of varying cooling rates on residual stresses are ...
Lutz Horbach +6 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen +4 more
wiley +1 more source
Vacuum‐Formed Composites Based on a Polyolefin and a High Content of Biomass‐Waste Fillers
Advanced Engineering Materials, EarlyView.It is shown here that by the use of a very ductile polymer matrix, it is possible to vacuum‐form products that contain up to 25% of hard biofillers with still ductile properties. The results are promising and opens up for the use of engineered biocomposites derived from industrial side‐stream biofillers in vacuum‐formed products. A strategy to increase
Susanna K. Källbom +6 more
wiley +1 more source
Performance Comparison of Surface Sensitizers for Diode Laser Powder Bed Fusion of Polyamide 12
Advanced Engineering Materials, EarlyView.Laser‐generated nanoparticles transform standard PA12 powders into high‐performance, dye‐free feedstocks for diode laser 3D printing. Despite identical absorbance at 808 nm, CuS, LaB6, and CB coatings reveal striking differences in fusion and strength—unlocking new design space for recyclable, industrial‐grade polymers.
Michael Willeke +9 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study uses real‐time laser diffraction image analysis to quantify fiber diameter changes and whipping behavior from the nozzle to the collector under varying electric field conditions. By capturing diffraction (scattering) intensity changes and bending angles, melt jet and whipping behavior are accurately assessed, supporting melt electrospinning ...
Jihwan Lim +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study designs Ta–Mo–Cr–Ti–Al refractory high‐entropy alloys with a disordered body‐centered‐cubic A2 crystal structure aiming for improved ductility, lower density, and oxidation resistance. Four alloy compositions are identified by thermodynamic calculations.
Kateryna Khanchych +7 more
wiley +1 more source
Summer Research Institute Interfacial and Condensed Phase Chemical Physics
, 2004 Stephan E. Barlow
openalex +2 more sources