Results 201 to 210 of about 208,420 (311)

Optimizing Laser Ablation of Stainless Steels for Volume Removal and Surface Quality Using Burst of Pulses

open access: yesAdvanced Engineering Materials, EarlyView.
This study explores the ablation efficiency and surface quality of laser‐treated stainless steel alloys (AISI 304, AISI 420, and AISI 316Ti) using an ultrashort pulsed laser and varying burst parameters (MHz, GHz, and Bi‐burst). Both ablation rates and surface quality parameters are determined, including isotropy surface roughness values, highlighting ...
Dirk Obergfell   +2 more
wiley   +1 more source

Micromechanical Insights into Sinter‐Based Additively Manufactured NiTi with Nb as a Sintering Aid

open access: yesAdvanced Engineering Materials, EarlyView.
This study investigates the microstructural and micromechanical behavior of NiTiNb made through filament‐based materials extrusion via chemically correlated nanoindentation. B19' remnants from the original powder lead to Nb gradients within NiTiNb grains due to the short sintering times required in liquid‐phase sintering.
Nerea Abando   +4 more
wiley   +1 more source

Emerging directions for biologically active fluids. [PDF]

open access: yesPhilos Trans A Math Phys Eng Sci
Smith DJ   +3 more
europepmc   +1 more source

Microcellular Poly (Ethylene‐Co‐Vinyl Acetate)/Lignin Nanocomposites for Soft Ferroelectrets

open access: yesAdvanced Engineering Materials, EarlyView.
Lignin valorization for advanced porous polymer nanocomposites development and an upscaling route for continuous manufacturing of soft ferroelectrets for energy harvesting are studied. This work examines the role of lignin and carbon nanotubes (CNT) in modifying the mechanical, dielectric, and ferroelectret properties of poly (ethylene‐co‐vinyl acetate)
Yuchen Lian   +5 more
wiley   +1 more source

Surface Modification of Fluorine‐Free Superhydrophobic Materials with (Ultra‐)Thin TiO2 Layers

open access: yesAdvanced Engineering Materials, EarlyView.
Significant changes in wettability, with a reduction of 60o in the water conduct angle, are reported via the surface modification of fluorine‐free superhydrophobic thin films, prepared by aerosol‐assisted chemical vapor deposition, after coating a 4 nm layer of titanium dioxide on the surface using atomic layer deposition.
Julie Jalila Kalmoni   +2 more
wiley   +1 more source

Adjustment of Coatings Morphology and Particle Distribution of Layered Silicates by Freeze‐Drying for Improved Gas Barriers

open access: yesAdvanced Engineering Materials, EarlyView.
Freeze‐drying of layered silicate is the key to get coatings with superior gas barrier. Freeze‐drying of layered silicates modified with dodecylamine (DDA) is a highly effective technique for the preparation of barrier pigments that significantly mitigate the permeation of oxygen, water vapor, and hydrogen through polymer films containing these ...
Joshua Lommes   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy